Zelmer Edek ZVC250 handleiding
Handleiding
Je bekijkt pagina 7 van 44
7
PL
EN
IMPORTANT WARNINGS
Prior to plugging in the product, check that your mains voltage is the same as the one indicated on the
product label.
The mains connection cable must not be tangled or wrapped around the product during use.
Do not pull on the connection cord in order to unplug it.
Do not use, connect or disconnect the device to the mains with your hands or feet wet.
Proceed according to the conservation and cleaning section of this manual for cleaning.
Unplug the product immediately from the mains in the event of any breakdown or damage and contact an
authorised Technical support service.
In order to prevent any risk of danger, do not open the device. Only qualied technical personnel from the
brand´s Ofcial Technical support service may carry out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the warranty null and void. Only an
authorised technical support service centre may carry out repairs on this product.
This appliance is designed exclusively for domestic use, in no case should be a commercial or industrial
use. In case of misuse or tampering with the product, it will be out of warranty.
Do not use the appliance to vacuum liquids (water, etc), sharp objects (pins, pins, nails, glass, etc),
incandescent objects (matches, cigarettes)
Never use the turbo brush to: Polish oors, suck (Liquids, wet or damp dust, hot ash, burning objects, such
as cigarettes, matches, sharp and hard items, such us: razors, pins, thumbtacks, pieces of glass, etc), our,
cement, plaster, printer or photocopier toner, etc.
B&B TRENDS SL. disclaims all liability for damages that may occur to people, animals or objects, for
the non-observance of these warnings.
Vacuum cleaner Operation
1. Connect the hose to vacuum cleaner: insert the hose end into the hose socket.
2. Adjust the length of the telescopic suction tube by sliding the slider according to the arrow and pull out/
pull the tube together (if the device is equipped with a telescopic tube).
3. Attach a nozzle or brush appropriate to your needs at the end of the suction tube.
4. Pull out the plug and power cord from the vacuum cleaner and insert the power cord plug into the
electrical outlet specied on the product label.
Before operation make sure that the dust bag is installed in the vacuum cleaner chamber and that inlet
lter
and the outlet lter is installed in the appliance.
5. Switch on the vacuum cleaner by pressing On/Off
6. Selected vacuum cleaner models are equipped with electronic power regulator, which allows you to
increase or decrease the power of the device.
Dust bag disassembly
1. When the indicator turns to be red, it is time replace with a new bag.
While pressing the locking clip, open the front cover until it locks in a vertical position.
Take out the bag holder then remove the full dust bag.
2. Replacing the outlet lter: by pressing the locking clip, remove the back cover and replace the lter with
a new one.
3. The motor protection lter should be removed and rinsed once a year, and can use it after dry. If the lter
is damage, a new lter should be replaced.
Do not start cleaning without an installed bag.
Bekijk gratis de handleiding van Zelmer Edek ZVC250, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Zelmer |
| Model | Edek ZVC250 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 3779 MB |
