YSI WaterLog H-4161 handleiding
Handleiding
Je bekijkt pagina 25 van 36
3.8 Change Sensor Address Command
The Change Sensor Address Command allows the sensor address to be changed. The address is
stored in non-volatile Flash memory within the sensor. The H-4161 will not respond if the
command was invalid, the address was out of range, or the Flash programming operation failed.
Command Response Description
"aAn! "n<cr><lf>" Change sensor address
Where:
a is the current (old) sensor address ("0-9", "A-Z", "a-z", "*", "?"). An ASCII "*"
may be used as a "wild card" address if the current address is unknown and only
one sensor is connected to the bus.
A is an upper-case ASCII character.
n is the new sensor address to be programmed ("0-9", "A-Z").
NOTE: To verify the new address use the "Identify Command."
Example of a "Change Sensor Address" command:
Command Response Description
"aA2!" "2<cr><lf>" Change sensor address to "2"
H-4161
SDI-12 Command and Response Protocol 3-9
Bekijk gratis de handleiding van YSI WaterLog H-4161, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | YSI |
| Model | WaterLog H-4161 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4210 MB |
