YSI 2900D handleiding
Handleiding
Je bekijkt pagina 153 van 172
11-10
POSSIBLE CAUSE: Calibrator bottle not primed.
ACTION: Prime calibrator bottle.
SECTION: 4.8 Prime the Fluid System
POSSIBLE CAUSE: Low calibrator solution.
ACTION: Install new calibrator.
SECTION: 4.7 Install Calibrator Solution(s)
POSSIBLE CAUSE: Pinched, blocked, leaking or disconnected tube.
ACTION: Fix or install new tubing.
SECTION: 9.4.7 Pump Tubing Replacement
POSSIBLE CAUSE: Calibrator pump not operating properly.
ACTION: Check pump and tubing.
SECTION: 7.2.2.3 Calibrator Pumps
POSSIBLE CAUSE: Fluid not conductive.
ACTION: Use saline as diluent.
POSSIBLE CAUSE: Sipper tip fouled.
ACTION: Clean tip of sipper with isopropyl alcohol and a lint-free tissue.
POSSIBLE CAUSE: Sipper mounting screws loose.
ACTION: Check sipper mounting screws and tighten gently if required.
SECTION: 9.4.11 Sipper Replacement
SYMPTOM: Fail FCN Test
POSSIBLE CAUSE: Damaged or old membrane.
ACTION: Replace membrane.
SECTION: 4.8 Prime the Fluid System
SYMPTOM: Fail Linearity Test
POSSIBLE CAUSE: Probe assignment incorrect.
ACTION: Make correct assignment.
SECTION: 4.10.1 Assign Chemistries to Probes
POSSIBLE CAUSE: Calibrator bottle assignment incorrect.
ACTION: Make correct assignment.
SECTION: 4.10.2 Assign Reagents
POSSIBLE CAUSE: Damaged or old Membrane.
ACTION: Replace membrane.
SECTION: 4.8 Prime the Fluid System
POSSIBLE CAUSE: Calibrator bottle(s) not primed sufficiently.
ACTION: Prime each calibrator bottle for 60 seconds.
SECTION: 4.8 Prime the Fluid System
POSSIBLE CAUSE: Contaminated or old calibration or linearity standard.
ACTION: Repeat test with new standards.
SECTION: 5.1 Perform Daily Operational Checks
POSSIBLE CAUSE: Assigned concentration range beyond practical limits.
ACTION: Redefine measurement parameters. Remake standards.
SECTION: 8 Chemistry Setup
SYMPTOM: ERROR: Motor Failure
POSSIBLE CAUSE: One of the motors is jammed.
ACTION: Enter motor service and cycle the suspected motor.
SECTION: 7.2 Service
Bekijk gratis de handleiding van YSI 2900D, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | YSI |
| Model | 2900D |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 50780 MB |
