Yato YT-8304 handleiding
Handleiding
Je bekijkt pagina 8 van 40
8
ORIGINAL INSTRUCTIONS
EN
PROPERTIES OF THE PRODUCT
The rectifi er is a device that permits to charge any kind of accumulators. The rectifi er converts the current and voltage in the power
network so as to guarantee a safe charging of accumulators. Charging facilitates a proper functioning of an accumulator, which
signifi cantly extends its life.
A correct, reliable and safe functioning of the device depends on its proper use, so:
Before you proceed to operate the device, read the manual thoroughly and keep it.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
The indicators in the housing of the device are not meters, as the notion is construed in the „Measurement Act”
TECHNICAL DATA
Parameter Measurement unit Value
Catalogue number YT-8304 YT-8305
Power network voltage [V AC] 230 230
Power network frequency [Hz] 50 50
Power network current [A] 1.7/2.5 2.1/3.8
Nominal charging voltage [V DC] 12/24 12/24
Charging current [A] 16 25
Accumulator’s capacity [Ah] 120 - 240 170 - 350
Insulation class II
Protection grade IP20 IP20
Mass [kg] 11,6 14,5
GENERAL SAFETY CONDITIONS
The device has not been designed to be used by persons (including children) of impaired
physical, sensory or mental capabilities, or those who lack the necessary experience and
knowledge, unless they are supervised or they have been trained in operation of the device
by the safety personnel.Preclude children from playing with the device. The rectifi er has been
designed to charge exclusively lead-acid accumulators. Charging any other type of accumu-
lators may lead to an electric shock, which is dangerous for health and life.It is prohibited to
charge non-rechargeable batteries! The charger must be under constant supervision during
charging. During charging the accumulator must be placed in a well ventilated area. It is
recommended to charge the accumulator at a room temperature. The rectifi er has been
designed to be operated in interiors, and it is prohibited to expose it to humidity, including
atmospheric precipitation.Electric Insulation Class I rectifi ers must be connected to sockets
equipped with a protection conductor.While charging accumulators in the electric system of
a car, fi rst the terminal of the rectifi er must be connected to the terminal of the accumulator,
which is not connected to the chassis of the vehicle, and then connect the other terminal of
the rectifi er to the chassis away from the accumulator and the fuel system. Then connect
the plug of the rectifi er to the power supply socket.Once the accumulator has been charged,
disconnect the plug of the rectifi er from the power supply socket, and then disconnect the ter-
minal of the rectifi er. Never leave the rectifi er connected to the power supply network. Always
remove the plug of the power cord from the power supply socket.Observe the polarity indica-
tions of the rectifi er and the accumulator. Before you commence charging the accumulator,
get acquainted with the charging instructions provided by the manufacturer of the accumula-
Bekijk gratis de handleiding van Yato YT-8304, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Yato |
| Model | YT-8304 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3827 MB |
Caratteristiche Prodotto
| Kleur van het product | Black, Orange |
| Ingebouwd display | Nee |
| Gewicht | 11600 g |
| Internationale veiligheidscode (IP) | IP20 |
| Oplaadspanning | 12 - 24 V |
