Yamaha WaveRunner JetBlaster (2025) Handleiding (124 Pagina's)

Handleiding

Operation

88

(4) After reaching land, stop the engine, and

then get off the watercraft and pull it up

on the beach.

To dock the watercraft (JETBLASTER):

(1) Make sure that there are no boats, swim-

mers, or obstacles near the dock.

(2) Release the throttle lever to reduce

speed about 80 m (260 ft) away from the

dock.

(3) Slowly approach the dock and stop the

engine just before coming alongside it.

WARNING! You need throttle to steer.

Shutting the engine off can cause you

to hit an obstacle you are attempting

to avoid. A collision could result in se-

vere injury or death.

[EWJ00602]

(4) Come alongside the dock and get off the

watercraft.

To dock the watercraft (JETBLASTER

DLX / JETBLASTER LTD):

(1) Make sure that there are no boats, swim-

mers, or obstacles near the dock.

(2) Release the throttle lever to reduce

speed about 80 m (260 ft) away from the

dock.

(3) Slowly approach the dock using the

throttle lever and RiDE lever to control

the watercraft speed.

(4) After coming alongside the dock, stop

the engine, and then get off the water-

craft.

EJU37194

Operating in weeded areas

Always avoid using your watercraft in areas

where weed growth is thick. If operating in

weeded areas is unavoidable, alternately

squeeze the throttle lever and relax your grip

on the throttle lever to vary the engine speed.

Weeds tend to become clogged more when

operating at a steady speed and at trolling

speed. If weeds may have clogged the intake

area, clean the jet intake. (See page 104 for

information on the jet intake.)

EJU40243

After removing the watercraft from

the water

ECJ01311

Do not run the engine over 4000 r/min on

land. Also, do not run the engine for more

than 15 seconds without supplying water,

otherwise the engine could overheat.

After operating and removing the watercraft

from the water, promptly discharge the re-

maining water from the cooling water pas-

sages.

To discharge water from the cooling wa-

ter passages:

(1) Make sure that the area around the wa-

tercraft is clear, and then start the en-

gine.

(2) Discharge the remaining water out of the

cooling water passages by alternately

squeezing and releasing the throttle lever

quickly for 10 to 15 seconds.

(3) Stop the engine.

UF5S70E0.book Page 88 Friday, October 11, 2024 9:51 AM

Bekijk gratis de handleiding van Yamaha WaveRunner JetBlaster (2025), stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.