Yamaha Rio1608-D3 handleiding
Handleiding
Je bekijkt pagina 5 van 44
Introduction
Rio3224-D3 Rio1608-D3 Reference Manual
5
Precautions for Rack Mounting
Operation of this device is guaranteed within a temperature range of 0 to 40°C. If you mount
this unit along with other Rio-D3 unit(s) or other device(s) in an EIA standard rack, the heat
from each device will raise the temperature inside the rack, which may prevent the unit from
achieving full performance. When rack mounting the unit, always observe the following
requirements to avoid heat buildup:
• If three or more Rio-D3 units are mounted without space in the same rack, set the fan
speeds to HIGH.
• If multiple units are mounted in the same rack with their fan speeds set to LOW, leave 1U
space between every two units. In addition, ensure sufficient ventilation by installing a
ventilation panel in these spaces, or simply leave the open spaces uncovered.
• When mounting the unit in a rack with devices such as power amplifiers that tend to
generate a significant amount of heat, leave 1U or more space between this unit and other
equipment. In addition, ensure sufficient ventilation by installing a ventilation panel in these
spaces, or simply leave the open spaces uncovered.
• To ensure sufficient airflow, leave the rear of the rack open and position it at least 10 cm
from walls, ceilings or other surfaces. If the rear of the rack cannot be left open, install a
commercially-available fan kit or similar forced ventilation system to secure sufficient airflow.
If you have installed a fan kit, there may be cases in which closing the rear of the rack will
produce a greater cooling effect. For more information, refer to the instruction manuals for
the rack and fan kit.
Recessed Installation
If you want to recess the front panel surface of the device from the front edge of the rack, you
can adjust the position of the rack mount brackets to recess the device by 50 mm or 100 mm,
as shown in the illustration below.
In the same way, rack mount hardware can also be attached to the rear panel surface.
NOTE
When you install the brackets, use the same screws that you just removed from the unit.
Source Code Distribution
For three years after the final factory shipment, you may request from Yamaha the source
code for any portions of the product which are licensed under the GNU General Public
License / GNU Lesser General Public License / RealNetworks Public Source License by
writing to the following address:
10-1 Nakazawa-cho, Chuo-ku, Hamamatsu, 430-8650, JAPAN
Global Marketing & Sales Department, Professional Solutions Division,
Musical Instruments & Audio Products Business Unit, Yamaha Corporation
The source code will be provided at no charge; however, we may require you to reimburse
Yamaha for the cost of delivering the source code to you. The source code can be
downloaded by visiting the following URL:
https://www.yamahaproaudio.com/
• Note that we shall bear no responsibility whatsoever for any damage arising from changes
(additions/deletions) made to the software for this product by a third party other than
Yamaha (or party authorized by Yamaha).
• Note that re-use of source code released to the public domain by Yamaha is not
guaranteed. Yamaha shall not bear any responsibility whatsoever for the source code.
50 mm
100 mm
Bekijk gratis de handleiding van Yamaha Rio1608-D3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Yamaha |
| Model | Rio1608-D3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5838 MB |
