Yamaha Rio1608-D3 handleiding
Handleiding
Je bekijkt pagina 27 van 44
Operations
Rio3224-D3 Rio1608-D3 Reference Manual
27
Setting the OUTPUT Channel Parameters
You can set the OUTPUT gain value (−96 dB to 24 dB), PHS (Phase) ON/OFF, DLY (Delay)
ON/OFF, and delay value. You can also apply the same procedure to the METER AES screen,
which is featured only on the Rio3224-D3.
1. While the METER OUT screen is displayed, turn the encoder with switch to select a
channel number.
The [SIG] indicator for the selected channel lights up once (Port Identify function).
2. Press the encoder with switch to display the parameter edit screen.
An editable parameter is highlighted.
3. Press the encoder with switch repeatedly to highlight the parameter you want to
edit, and then turn the encoder to modify the parameter value.
Turning the encoder with switch immediately changes and confirms the gain and delay
values. On the other hand, you must press the encoder with switch to confirm a change
to the ON/OFF setting for PHS (Phase) or DLY (Delay).
NOTE
• The delay value set from the Rio-D3 is specified in milliseconds (ms). If you want to specify this
value in microseconds (μs), do so from a supported device.
• Press and hold the encoder with switch to return to the previous parameter selection.
4. When you finish setting the parameters, press the [ ] (Back) key to return to the
METER OUT screen.
Related link(s)
“METER OUT
”
“METER AES
”
Selecting the Channel(s) to be Assigned to the
PHONES OUT Port
This setting supports both monaural and stereo signals.
1. While the PHONES screen is displayed, turn the encoder with switch to select a
channel number.
The selected channel is immediately confirmed. When the channel is selected, the
corresponding indicators ([+48V], [SIG], and [PEAK] indicators for the INPUT port; [SIG]
indicator for the OUTPUT port) light up once (Port Identify function).
NOTE
• If you assign a monaural channel, set the R ch to MONO, or assign the same channel number to
the L ch and R ch.
• You can also select the last two Dante receive channels, which enables you to send any audio
signal from a supported mixer to PHONES (for example, for the purpose of communication
between engineers, or FOH audio transmission).
2. To switch between L ch and R ch selection, press and hold the encoder with switch.
Related link(s)
“PHONES Screen
”
“Setting the Parameters for the Selected PHONES Source
”
(Example) METER OUT 1-8 screen
Selected channel number
Parameter edit screen
Editable parameter
PHONES screen
Selected channel number
Bekijk gratis de handleiding van Yamaha Rio1608-D3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Yamaha |
| Model | Rio1608-D3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5838 MB |
