Handleiding
Je bekijkt pagina 12 van 44
English - 12
PROBLEM POSSIBLE CAUSE SOLUTION
Cyber Duster
does not start
No electricity. Check for power supply.
The power cord is not properly
plugged in.
Remove and reconnect the power
cord.
Battery is not activated yet. Please charge the battery until full
prior to initial use.(See Page 8:
Charge the Battery)
Low battery capacity. When the battery capacity is 20%
or lower, in order to protect the
battery, the preset program will
stop the machine and prohibit the
machine from working again. (See
Page 8: Charge the Battery)
Battery can’t
be charged
Charger malfunctions or battery is
permanently damaged.
Contact XPOWER for additional
assistance.
Unit runs but
the speed
/ noise is
abnormal
Air inlet or air outlet is blocked. Remove blockage and clean the
filter or nozzle attachment.
Low battery capacity. (See Page 8: Charge the Battery)
This product uses a high RPM
motor to provide powerful airflow
and could create a certain level of
noise. This is a normal sound.
Use a wider opening nozzle
attachment, switch to the lower
speed setting or operate in a
outdoor place.
Abnormal
Temperature
of the airflow
or housing
This product generates powerful
motor heated air. After a
prolonged use, the airflow and
the machine surface might reach
a high temperature.
Stop using for at least one hour
until fully cooled down. Clean the
filter and check if the air inlet or
outlet is blocked. Use a glove the
isolate the heat coming from the
housing.
Nozzle falls off The nozzle is not properly
installed.
Follow the installation guide.
Secure the nozzle before use.
Troubleshooting Guide
Bekijk gratis de handleiding van XPower A-3B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | XPower |
| Model | A-3B |
| Categorie | Heater |
| Taal | Nederlands |
| Grootte | 3528 MB |
