Xiaomi G20 handleiding
Handleiding
Je bekijkt pagina 10 van 154
9
Error Possible Cause Solution
The air duct is blocked.
Check and clean the dust compartment,
filter, pre-filter, post-filter, extension rod,
extension hose, or brush head.
The brush head is tangled. Check and clean the brush head.
The battery overheat protection
is triggered.
Wait until the battery temperature returns
to normal, and then try to use it again.
The screen displays the error
code E0, E1, E2, E3, or E4.
Contact the after-sales service team.
Troubleshooting
If the vacuum cleaner is not working properly, the screen will show an error message. Refer to the table below for
the resolution.
Common Issue Possible Cause Solution
The vacuum cleaner
does not work.
Battery is depleted. Charge the vacuum cleaner before use.
The suction opening, air duct, pre-
filter, or post-filter is blocked.
Check and clean immediately.
The filter, pre-filter, or post-filter is not
installed in place.
Check and install in place.
The battery overheat protection is
triggered.
Wait until the battery temperature returns to
normal, and then try to use it again.
The suction power
reduces.
The dust compartment is full, or the
pre-filter or the post-filter is blocked.
Check and clean immediately.
Brush head is clogged. Clean the brush head.
Low battery life.
Battery is not fully charged. Charge the vacuum cleaner before use.
The dust compartment is full, or the
pre-filter or the post-filter is blocked.
Check and clean immediately.
Brush head is clogged. Clean the brush head.
The roller brush
does not rotate.
The roller brush is stuck by foreign
objects.
Remove any foreign object, and then resume use.
The conductive contacts on the
brush head or extension rod are dirty.
Turn the vacuum cleaner off, and remove the
brush head. Wipe the conductive contacts with a
soft, dry cloth, then try again.
The vacuum cleaner
does not charge.
The power supply being used is not
genuine.
Only use the genuine power supply to charge the
vacuum cleaner.
The battery charges
slowly.
The battery overheat protection is
triggered.
Wait until the battery temperature returns to
normal, and then try to use it again.
Note: If the solutions above do not resolve the issue, please contact the after-sales service team.
Common Issue
Xiaomi Vacuum Cleaner G20 Max
Name Cordless Vacuum Cleaner Model D206
Rated Voltage 25.2 V
⎓
Rated Power 520 W
Charging Voltage 31.0 V
⎓
Net Weight 4.25 kg
Electric Brush Bar (Equipped with Headlight)
Model D206-DS Rated Voltage 21.6 V
⎓
Rated Power 30 W
Mini Electric Brush
Model D206-MN Rated Voltage 21.6 V
⎓
Rated Power 10 W
Power Supply
Manufacturer FOSHAN SHUNDE GUANYUDA POWER SUPPLY CO., LTD.
Model GC32-310100-2A Average Active Efficiency 87.76%
Rated Input 100-240 V
～
50/60 Hz 1.0 A Efficiency at Low Load (10%) 81.28%
Rated Output 31.0 V
⎓
1.0 A, 31.0 W No-load Power Consumption 0.09 W
Specifications
Environmental Notice
The rechargeable lithium-ion battery pack of this vacuum cleaner contains chemicals that may pollute the
environment. Before disposing of the vacuum cleaner, remove the batteries and then discard them at an
appropriate recycling facility.
- The battery must be removed from the appliance before it is scrapped.
- The appliance must be disconnected from the supply mains when removing the battery.
- The battery is to be disposed of safely.
Cautions:
• Make sure the vacuum cleaner is disconnected from power and the batteries are fully drained before battery
removal.
• Take the removed batteries to the professional recycling facility to properly dispose of them.
• Do not leave the batteries in a high-temperature environment; otherwise, they may explode.
• In the event of a battery leak, avoid contact with the liquid. If the liquid enters the eyes, rinse with plenty of water
and seek medical attention immediately.
Steps to Remove the Battery:
1. Remove the five screws from the lower cover of the vacuum cleaner, and take out the lower cover and charging
contacts' connection cable.
2. Remove the LED screen assembly and the wiring.
3. Remove the two screws from the front cover of the vacuum cleaner and remove the front cover.
4. Remove the rear cover and unplug the switch wiring from the circuit board.
5. Remove the main body and take out the battery pack.
Bekijk gratis de handleiding van Xiaomi G20, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Xiaomi |
| Model | G20 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 16252 MB |
