Wolkenstein WT3-90-A+BR handleiding
Handleiding
Je bekijkt pagina 61 van 93
~ 61 ~
HORIZONTALLY: lay the exhaust hose to an exhaust
outlet equipped with an air grille*.
Fig. similar.
*
Article not included in the scope of delivery.
2.5.1 Installation of the one-way valve
❖ If your appliance does not have the one - way valve installed at the factory, you
still need to install it. The following figures only show an example of the standard
installation of an one - way valve, as the exhaust air outlet may vary depending on
the model and configuration of the appliance.
❖ The one - way valve consists of two flap parts (a / b). You must install both flap
parts individually in the housing of the exhaust air outlet (c / s. fig. below).
a
ONE - WAY VALVE: flap part « a »
b
ONE - WAY VALVE: flap part « b »
c
HOUSING OF THE EXHAUST AIR OUTLET
INSTALLATION STEPS
1. Each of the two individual flap parts (a / b) consist of a semicircle including an
axle (d). In the centre of the axle (d) of a flap part is an axle pin (e / s. fig. below).
2. Insert the axle (d) of a flap part carefully into the corresponding openings (f / on
both sides) in the housing of the exhaust air outlet (c); the axle pin (e) must point
upwards (s. fig. below).
3. Repeat step 2 for the other flap part.
4. Ensure that both parts of the one - way valve are installed properly. The flap parts
must not jam or get caught.
Bekijk gratis de handleiding van Wolkenstein WT3-90-A+BR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wolkenstein |
| Model | WT3-90-A+BR |
| Categorie | Afzuigkap |
| Taal | Nederlands |
| Grootte | 14815 MB |
