Wiesenfield WIE-PM-400 handleiding
Handleiding
Je bekijkt pagina 13 van 138
EN
Wear protective clothing.
ATTENTION! Electric shock warning!
ATTENTION! Loud noise warning!
ATTENTION! Rotating parts, entanglement hazard!
ATTENTION! Hand crush hazard!
PLEASE NOTE! Drawings in this manual are for illustration purposes only and in some details may
differ from the actual product.
2. Usage safety
ATTENTION!
Read all safety warnings and all instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or serious injury or even death.
The terms "device" or "product" are used in the warnings and instructions to refer to:
Hammer mill
2.1. Electrical safety
a) The device should be connected to three-phase electric power with a three-phase extension cord. The
plug must fit the socket. Do not modify the plug in any way. Using original plugs and matching sockets
reduces the risk of electric shock.
b) Avoid touching earthed elements such as pipes, heaters, boilers and refrigerators. There is an
increased risk of electric shock if the earthed device is exposed to rain, comes into direct contact with
a wet surface or is operating in a damp environment. Water getting into the device increases the risk
of damage to the device and of electric shock.
c) Do not touch the device with wet or damp hands.
d) Use the cord only for its designated use. Never use it to carry the device or to pull the plug out of a
socket. Keep the cable away from heat sources, oil, sharp edges or moving parts. Damaged or tangled
cables increase the risk of electric shock.
e) If working with the device outdoors, make sure to use an extension cord suitable for outdoor use.
Using an extension cord suitable for outdoor use reduces the risk of electric shock.
f) If using the device in a damp environment cannot be avoided, a residual current device (RCD) should
be applied. The use of an RCD reduces the risk of electric shock.
g) Do not use the device if the cord is damaged or shows obvious signs of wear. A damaged cord should
be replaced by a qualified electrician or the manufacturer‘s service centre.
h) To avoid electric shock, do not immerse the cord, plug or device in water or other liquids. Do not use
the device on wet surfaces.
i) As a matter of significant current draw during engine start-up, it is recommended to restart the engine
after several minutes of break.
2.2. Safety in the workplace
a) Make sure the workplace is clean and well lit. A messy or poorly lit workplace may lead to accidents.
Try to think ahead, observe what is going on and use common sense when working with the device.
b) If there are any doubts as to the correct operation of the device, contact the manufacturer's support
service.
c) Only the manufacturer's service point may repair the device. Do not attempt any repairs
independently!
Bekijk gratis de handleiding van Wiesenfield WIE-PM-400, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wiesenfield |
| Model | WIE-PM-400 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 49276 MB |
