Wiesenfield WIE-PM-3300 handleiding
Handleiding
Je bekijkt pagina 8 van 66
EN
6. Clean the feeder unit and working unit before running the machine.
Troubles and Solutions
Fault Possible Causes Solutions
Not crashing or crashing
inefficiency.
1. Low speed.
2. Damaged sieve.
3. Worn teeth or hammer.
4. Wet material.
5. Damaged driving shaft.
1. Maintain rated speed.
2. Replace sieve.
3. Replace teeth/hammer.
4. Dry material.
5. Maintain or replace the driving shaft.
Temperature of bearing is
too high.
1. Insufficient lubricant.
2. Worn bearing.
3. Excessive feed.
1. Replace grease.
2. Replace bearing.
3. Control feed volume.
Machine vibration or noise. 1. Loose parts.
2. Rotor imbalance.
3. Damaged driving shaft.
1. Fasten parts.
2. Balance rotor.
3. Maintain or replace shaft.
Maintenance
Ensure the bearing has sufficient and clean lubrication.
Regularly check and replace damaged parts such as square teeth, T-teeth, or sieves.
Tighten or replace the triangle belt as needed.
Damageable Parts
Square gear
T-type gear
Powder sieve
Triangle belt
Bearing
Bekijk gratis de handleiding van Wiesenfield WIE-PM-3300, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wiesenfield |
| Model | WIE-PM-3300 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5974 MB |
