Wiesenfield WIE-PM-2800 handleiding
Handleiding
Je bekijkt pagina 38 van 372
EN
Worn bearing(s).
Clean the area and replace
the bearings
2. Low
performance of
the machine.
Grinding hammers badly
worn.
Turn them on the mount or
replace them with new ones.
Grinding plates are badly
worn.
Replace with new ones.
Too large pieces of thrown-
out material.
Reduce the size of the pieces
of raw material to be
processed.
3. Bearings
overheat.
The processed raw material
is too moist.
First, dry the raw material
that is to be processed.
Raw material flow is too
high.
Control the supply of raw
material to the hopper.
Inadequate distance
between the bearings and
their base.
Improve their assembly.
Dirty bearings.
Clean the bearings with
extraction gas.
Bearings too poorly
lubricated.
Lubricate them thoroughly.
The speed is too high.
Wrong roller selection or
defective motor.
Worn bearing.
Replace with new ones.
4. The raw material
is discharged
through the air
intake (on the
housing).
The flow of raw material is
too fast or uneven.
Adjust the amount of raw
material fed to the machine.
The voltage and therefore
the engine speed are too
low
Check and adjust the engine.
The material tube leading
to the outlet is clogged
Clean the pipe.
The air intake is too high or
too low
Adjust the inlet holes with
the knob on the housing.
Bekijk gratis de handleiding van Wiesenfield WIE-PM-2800, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wiesenfield |
| Model | WIE-PM-2800 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 121963 MB |
