Wiesenfield WIE-PM-2700 handleiding
Handleiding
Je bekijkt pagina 30 van 296
EN
h) When transporting or moving the device from storage to the place of use,
observe the health and safety rules for manual handling applicable in the
country where the device is used.
i) Avoid situations in which the device stops under heavy loads during operation.
This can cause overheating of the drive elements and consequent damage to
the equipment.
j) Do not touch any moving parts or accessories unless the device is unplugged.
k) Do not move, shift, or rotate the device while in operation.
l) Do not leave the device switched on unattended.
m) Clean the device regularly to prevent permanent dirt build-up.
n) Do not obstruct the air inlet or outlet.
o) The product is not a toy. Cleaning and maintenance must not be performed by
children without adult supervision.
p) Do not tamper with the device to alter its performance or design.
q) Keep the unit away from sources of fire and heat.
r) Do not overload the device.
s) Do not block the ventilation openings of the unit! Before each use, make sure
that the nozzle is properly mounted in the machine and that the hose is
properly attached and undamaged.
t) Before turning on the unit, open the outlet hatch and place a suitable
container under it to avoid clogging.
u) Before each use, check that no undesirable objects or stones have fallen into
the hopper.
v) When filling the hopper, do not push the contents too far! Risk of injury to your
hands.
w) Regularly carry out a periodic inspection of the device in the service center.
x) Before use, check the correct connection of the device to the power supply
and the stability of the assembly, e.g. by tightening the screws. Do not obstruct
the air inlet or outlet.
y) Use the device on an even and stable surface. Fasten if necessary. The working
environment should protect the device from getting wet or against
unfavorable weather conditions and ensure a free distance to the charging
hopper and outlet.
z) Before working with the device, turn on the device for a few minutes with an
empty hopper to check that the device is functioning properly. If it makes
unwanted sounds or shocks, turn off and repair the device. Do not work with
a damaged device!
aa) It is recommended to turn off the machine only after the material in the mill is
completely ground (except for an emergency).
bb) It is forbidden to look into the outlet after starting the device. Risk of face
damage.
Bekijk gratis de handleiding van Wiesenfield WIE-PM-2700, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wiesenfield |
| Model | WIE-PM-2700 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 63234 MB |
