Wiesenfield WIE-EMM-100 handleiding
Handleiding
Je bekijkt pagina 8 van 82
EN
Schematic diagram
Based on the pressure principle, when the machine starts, air is extracted from the bottle, creating lower
pressure inside the bottle compared to the pressure in the udder. This pressure difference causes the milk
to flow gradually into the breast pump.
Cleaning and maintenance
1. After milking, promptly transfer the milk to the storage tank. Rinse off any dirt from the outside of the
milking cup cluster with clean water. Place the cleaned milking cup cluster into a bucket containing hot
water or disinfectant and start the milking machine to allow it to run for several cycles. This will clean the
milking cup cluster, milk bucket, and milk tube. Finally, rinse them with clean water until all traces of
disinfectant are removed.
2. Once a week, disassemble the milk tube, milk bucket, milking cup cluster, and other parts for thorough
cleaning.
3. To extend the machine's service life, clean the inner lining and store it in a cool place to preserve the
rubber. Check for cracks or deformation in the inner lining before each use and replace it if necessary.
4. Inspect all non-toxic rubber tubes for cracks and replace them immediately if any are found.
Troubleshooting
Problem Possible cause Solution
Abnormal sound
The loose connection between
moving parts.
Check and tighten the connection, nut,
and others between moving parts.
Low or no suction
1. The seal ring of the milk bucket
cover is not sealed.
1. Check whether the seal ring is in
good condition and whether the
installation is in place. Ensure the
sealing of the milk bucket.
2. The milking cup group and its
pipeline have cracks, and the
joints are not properly sealed,
resulting in leaks.
2. Check the endotheca and
pipeline of the milk cup. If there
are cracks, replace them in time.
Motor slip
The vacuum is too high with
an excessive load.
Remove the milk cup group in time
and let the air enter, breaking the
vacuum state. Check whether the milk
Bekijk gratis de handleiding van Wiesenfield WIE-EMM-100, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wiesenfield |
| Model | WIE-EMM-100 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 22374 MB |
