Handleiding
Je bekijkt pagina 11 van 40
11
Mark and Drill Rear Wall
The microwave oven must be installed on a minimum of 1 wall
stud, preferably 2, using a minimum of 1 lag screw, preferably 2.
See “Find the Wall Stud(s)” section for find the wall studs.
Align the center markers on the cardboard template or wall
template, to the centerline on the wall, making sure it is level, and
that the top of the cardboard template or wall template is butted up
against the back edge of the upper cabinet. (See following NOTE
before making marks).
1. Attach the cardboard template or wall template to wall, Align
the center markers on the cardboard template or wall
template, to the centerline on the wall, making sure it is level,
and that the top of the cardboard template or wall template is
butted up against the back edge of the upper cabinet. (See
following NOTE before making marks).
NOTE: If the front edge of the upper cabinet is lower than the
back edge, lower the cardboard template or wall template so
that its top is level with the front edge of the cabinet.
A
C
D
B
A. Rear wall
B. Cardboard template or wall template
C. Top of cardboard template or wall template must
align with front edge of cabinet.
D. Front edge of the upper cabinet
2. Drill holes at A (A and B marks on the cardboard template or
wall template), if the Wall studs are not located A and B hole,
do not drill A and B hole, and follow the below instruction
A
B
C
D
A. A and B holes
B. Arrows to upper cabinet
C. Center marks on cardboard template or wall template
D. Back edge of upper cabinet
3. In addition to being installed on at least 1 wall stud, the
mounting plate must attach to the wall at both end holes. If the
end holes are not over wall studs, use two 3/16-24 x 3" round
head bolts with toggle nuts; if 1 end hole is over a wall stud,
use 1 lag screw and one 3/16-24 x 3" round-head bolt with
toggle nut; or if both end holes are over wall studs, use 2 lag
screws. Following are 3 installation configurations.
Installation for No Wall Studs at End Holes (Figures 1 and
2 in Find the Wall Stud(s) section)
1. Drill 5/8" (1.6 cm) holes through the wall at both end holes
marked in Step 3 of the “Mark Rear Wall.”
2. Drill 3/16" (5 mm) hole(s) into the wall stud(s) at the
hole(s) marked in step 6 of the “Mark Rear Wall.” Refer to
figures 1 and 2 in “Possible Wall Stud Configurations” in
the “Locate Wall Studs(s)” section.
Installation for Wall Stud at One End Hole (Figure 3 in
Find the Wall Stud(s) section)
1. Drill a 3/16" (5 mm) hole into the wall stud at the end hole
marked in Step 3 of the “Mark Rear Wall.”
2. If installing on a second wall stud, drill a 3/16" (5 mm) hole
into the wall stud at the other hole marked in Step 6 of the
“Mark Rear Wall.” Refer to Figure 3 in “Possible Wall Stud
Configurations” in the “Locate all Stud(s)” section.
3. Drill a 5/8" (1.6 cm) hole through the wall at the other end.
Installation for Wall Studs at Both End Holes (Figure 4 in
Find the Wall Stud(s) section)
1. Drill 3/16” (5 mm) holes into the studs at the end holes
marked in Step 3 of the “Mark Rear Wall.”
2. Using a keyhole saw, cut out the rectangular wall venting
cutout area. Skip this step if for recirculation venting or roof
venting installation.
A
A. Wall Venting Cutout Area
Attach Mounting Plate to Wall
1. Position mounting plate on the wall.
2. Secure the mounting plate to the wall at both end holes drilled
into the wall studs and/or drywall using either 3/16-24 x 3"
round-head bolts and toggle nuts or 1/4 x 2" lag screws.
Refer to illustrations in “Possible Wall Stud Configurations” in
the “Locate Wall Stud(s)” section, and the following sections
“No Wall Studs at End Holes (Figures 1 and 2 in Find the Wall
Stud(s) section)” or “ Wall Stud at One End Hole (Figure 3 in
Find the wall Stud(s) section)”.
3. Insert lag screws into both end holes.
4. Check alignment of mounting plate, making sure it is level.
5. Secure the two end hole screws.
Bekijk gratis de handleiding van Whirlpool YWMMS3130RB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | YWMMS3130RB |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 6153 MB |
