Handleiding
Je bekijkt pagina 14 van 56
14
Using the Controls
IMPORTANT:
■ Wait 24 hours for your refrigerator to cool completely before
adding food. If you add food before the refrigerator has
cooled completely, your food may spoil.
NOTE: Adjusting the refrigerator and freezer temperature
controls to a colder than recommended setting will not cool
the compartments any faster.
■ The recommended setting should be correct for normal
household refrigerator use. The controls are set correctly
when milk or juice is as cold as you like and when ice cream
is rm.
■ If the temperature is too warm or too cold in the refrigerator
or freezer, rst check the air vents to be sure they are not
blocked before adjusting the controls.
Control Panel
Depending on your model, your refrigerator has either an internal
control panel, located at the top of the refrigerator compartment,
or an external control panel, located above the external water
dispenser. Follow the instructions specic to your model.
Internal Control Panel
External Control Panel
IMPORTANT (External Control only): The display screen on
the dispenser control panel will turn off automatically and enter
“sleep” mode when the control buttons and dispenser paddles
have not been used for 2 minutes or more. While in “sleep”
mode, the rst press of a control button will only reactivate the
display screen, without changing any settings. After reactivation,
changes to any settings can then be made. If no changes are
made within 2 minutes, the display will re-enter “sleep” mode.
■ Touch any control button on the dispenser panel to activate
the display screen.
Temperature Control
For your convenience, the temperature control is preset at the
factory. When you rst install your refrigerator, make sure the
control is still set to the recommended setting as shown.
Recommended Setting “3 Snowakes”
Adjusting the Controls
If you need to adjust the temperature in either the refrigerator or
freezer compartment, use the settings listed in the following chart
as a guide.
■ Press the Temp button to display the desired number of
snowakes from 1 snowake (least cold) to all
5 snowakes (coldest).
NOTE: Except when starting the refrigerator, do not adjust the
control more than one setting at a time. Wait 24 hours between
adjustments for the temperature to stabilize.
CONDITION/REASON: ADJUSTMENT:
REFRIGERATOR too warm FRIDGE TEMP
one more snowake
FREEZER too warm/too little ice FREEZER TEMP
one more snowake
REFRIGERATOR too cold FRIDGE TEMP
one less snowake
FREEZER too cold FREEZER TEMP
one less snowake
Cooling On/Off
Your refrigerator and freezer will not cool when cooling is turned
off. Follow the directions specic to your model.
Internal Control Panel
■ To turn cooling off, press and hold both the Fast Cool
and Moisture Control buttons at the same time for 3 seconds.
When cooling is OFF, “Cooling Off” will appear on the display
screen.
■ To turn cooling back on, press and hold both the Fast Cool
and Moisture Control buttons at the same time for 3 seconds.
When cooling is ON, “Cooling Off” will disappear and the
previously selected settings will appear on the display screen.
Bekijk gratis de handleiding van Whirlpool WRF560SFHW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WRF560SFHW |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 7778 MB |
