Handleiding
Je bekijkt pagina 11 van 56
11
Door Closing and Door Alignment
IMPORTANT: To comply with American Disabilities Act (ADA)
guidelines, fully retract the rollers into the cabinet to lower the
refrigerator.
Door Closing
The base grille covers the leveling screws and roller assemblies
located at the bottom of the refrigerator cabinet below the freezer
drawer. Before making adjustments, remove the base grille and
move the refrigerator to its nal location.
1. Remove the base grille. Grasp the grille rmly and pull it
toward you.
2. Move the refrigerator to its nal location.
NOTE: To allow the refrigerator to roll easier, raise the
leveling legs off the oor by turning the leveling screws
counterclockwise. The front rollers will be touching the oor.
3. So the doors will close easier, use a 1/4" hex driver to turn
both leveling screws clockwise. This will raise the front of
the refrigerator tilting it slightly downward to the rear. Turn
both leveling screws the same amount.
NOTE: Having someone push against the top of the
refrigerator takes some weight off the leveling screws. This
makes it easier to turn the screws.
4. Open both doors again to make sure they close as easily as
you like and that they stay closed. If not, tilt the refrigerator
slightly more to the rear by turning both leveling screws to the
right. It may take several more turns.
NOTE: To keep the refrigerator level, you should turn
both leveling screws the same amount.
5. Replace the base grille.
■ Pull open the freezer drawer.
■ Align the 3 clips on the back of the base grille with the 3
tabs at the base of the refrigerator.
■ Push the base grille in toward the refrigerator until it is
rmly in place
Door Alignment
If the space between the refrigerator doors and freezer drawer
looks uneven, you can adjust it using the following instructions:
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a 5/16" socket or wrench.
3. Have someone hold the door in place or put a spacer
between the doors and drawer.
4. Tighten the top hinge screws once the door is in the desired
location.
5. Replace the top hinge cover.
FILTERS AND
ACCESSORIES
Water Filtration System
Water Filter Status Light
The water lter status light on the control panel will help you
know when to order and replace the water lter.
■ GOOD - The water lter icon on the control lights up in BLUE.
■ ORDER a replacement lter - The water lter icon on
the control lights up in YELLOW.
■ REPLACE the water lter - The water lter icon on the control
lights up in RED and “Replace Filter” will appear on the
display.
■ EXPIRED - The water lter icon lights up in RED and “Replace
Filter” ashes on the display.
NOTE: If water ow to your water dispenser or ice maker
decreases noticeably, change the lter sooner. The
disposable water lter should be replaced at least every
6 months, depending on your water quality and usage.
■ After changing the water lter, reset the status. Press and
hold the Water Filter button for 3 seconds. When the system
is reset, the water lter icon will return to BLUE and the words
“Replace Filter” will disappear from the display.
A
B
1/4"
A. Leveling screw
B. Front roller
A
B
A. Tab
B. Clip
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Bekijk gratis de handleiding van Whirlpool WRF560SFHW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WRF560SFHW |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 7778 MB |
