Handleiding
Je bekijkt pagina 34 van 48
Read the “Safety Instructions” section first!
4 Installation
4.1. Appropriate Installation
Location
Contact an Authorized Service for the
installation of the product. In order to prepare
the product for use, refer the information in
the user manual and ensure that electrical
installation and water installation are
appropriate. If not, call a qualified electrician
and technician to have any necessary
arrangements carried out.
B
WARNING:
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorized persons.
B
WARNING:
Product must not be plugged in
during installation. Otherwise,
there is the risk of death or
serious injury!
A
WARNING:
If the door clearance of the room
where the product shall be place
is so tight to prevent passing of
the product, remove the door of
the room and pass the product
through the door by turning it to
its side; if this does not work,
contact the authorized service.
• Place the product on an even floor
surface to prevent jolts.
• Install the product at least 30 cm away
from heat sources such as hobs, heater
cores and stoves and at least 5 cm away
from electrical ovens.
• Product must not be subjected to direct
sun light and kept in humid places.
• Please provide at least 5cm distance for
air circulation between the back side of
your product and the wall to avoid
condensation on the rear panel of
product.
• Appropriate air ventilation must be
provided around your product in order to
achieve an efficient operation. If the
product is to be placed in a recess in the
wall, pay attention to leave at least 5 cm
distance with the ceiling and side walls.
• Your product requires adequate air
circulation to function efficiently.
If the product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
• If the product will be placed in an alcove,
remember to leave at least 5 cm
clearance between the product and the
ceiling, rear wall and the side walls.
Check if the rear wall clearance
protection component is present at its
location (if provided with the product). If
the component is not available, or if it is
lost or fallen, position the product so that
at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient
operation of the product.
4.2. Adjusting the Feet
If the product stands unbalanced after
installation, adjust the feet on the front by
rotating them to the right or left.
10 / 22 EN
Refrigerator / User Manual
Bekijk gratis de handleiding van Whirlpool WHK 26402 XP4U, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WHK 26402 XP4U |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 4783 MB |
