Handleiding
Je bekijkt pagina 4 van 44
EN / 4
*Optional: Figures in this user manual are
schematic and may not exactly match your
product. If your product does not comprise
the relevant parts, the information pertains
to other models.
3 Installation
Read the “Safety Instructions” first!
3.1 Right Place For Installation
Contact the Authorized Service for the
product's installation. To prepare the
product for installation, see the information
in the user manual and make sure the elec-
tric and water utilities are as required. If
not, call an electrician and plumber to ar-
range the utilities as necessary.
• Place the product on a flat surface to
avoid vibration
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• When placing two coolers in adjacent po-
sition, leave at least 4 cm distance
between the two units.
• Keep the product out of direct sunlight
and in a dry place.
• Your product requires adequate air circu-
lation to function efficiently. If you place
the product in an alcove, remember to
leave at least 5 cm clearance between
the product and the ceiling, rear wall and
the side walls.
• Check if the rear wall clearance protec-
tion component is present at its location
(if provided with the product).
• If the component is not available, or if it
is lost or fallen, position the product so
that at least 5 cm clearance shall be left
between the rear surface of the product
and the wall of the room. The clearance
at the rear is important for efficient oper-
ation of the product.
3.2 Attaching the Plastic Wedges
The condenser of the refrigerator is located
at the rear. To minimize power consump-
tion and increase energy efficiency the top
and bottom of the condenser must be
pulled back and secured as shown in the
picture. When the condenser is pulled back-
wards, the brackets lock and the con-
denser's position is secured.
3.3 Adjusting the Legs
If the product is not in balanced position,
adjust the front adjustable legs by rotating
them to right or left.
3.4 Hot Surface Warning
The side walls of your product are equipped
with cooler pipes to enhance the cooling
system. High pressure fluid may flow
through these surfaces, and cause hot sur-
faces on the side walls. This is normal and
it does not require servicing.
4 Operating the Product
Read the “Safety Instructions” first!
Bekijk gratis de handleiding van Whirlpool WHK 26402 XP4E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WHK 26402 XP4E |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 3869 MB |
