Handleiding
Je bekijkt pagina 5 van 65
EN / 5
*Optional: Figures in this user manual are
schematic and may not exactly match your
product. If your product does not comprise
the relevant parts, the information pertains
to other models.
3 Installation
Right place for installation
Read the “Safety Instructions” first!
Contact the Authorized Service for the
product's installation. To prepare the
product for installation, see the information
in the user manual and make sure the elec-
tric and water utilities are as required. If
not, call an electrician and plumber to ar-
range the utilities as necessary.
• Damaged power cable must be replaced
by Authorized Service.
• When placing two coolers in adjacent po-
sition, leave at least 4 cm distance
between the two units.
• Keep the product out of direct sunlight
and in a dry place.
• Your product requires adequate air circu-
lation to function efficiently. If you place
the product in an alcove, remember to
leave at least 5 cm clearance between
the product and the ceiling, rear wall and
the side walls. Check if the rear wall
clearance protection component is
present at its location (if provided with
the product). If the component is not
available, or if it is lost or fallen, position
the product so that at least 5 cm clear-
ance shall be left between the rear sur-
face of the product and the wall of the
room. The clearance at the rear is import-
ant for efficient operation of the product.
• If the door span is too narrow for the
product to pass, remove the door and
turn the product sideways; if this does
not work, contact the authorized service.
• Place the product on a flat surface to
avoid vibration
• Place the product at least 30 cm away
from the heater, stove and similar
sources of heat and at least 5 cm away
from electric ovens.
• Do not expose the product to direct sun-
light or keep in damp environments.
• Before transport or use, never open the
control board cover on the product. Risk
of electric shock and fire!
• Our firm will not assume responsibility
for any damages due to usage without
earthing and without power connection in
compliance with national regulations.
• The power cable plug must be easily ac-
cessible after installation.
Hot surface warning!
The side walls of your product are equipped
with cooler pipes to enhance the cooling
system. High pressure fluid may flow
through these surfaces, and cause hot sur-
faces on the side walls. This is normal and
it does not require servicing. Be careful
when you contact these areas.
Attaching the plastic wedges
Use the plastic wedges provided with the
product to maintain sufficient space for air
circulation between the product and the
wall.
• Remove the screws on the product and
mount the screws provided with the
wedges.
• Attach 2 plastic wedges on the ventila-
tion cover as shown in the figure.
Adjusting the Legs
If the product is not in balanced position,
adjust the front adjustable stands by rotat-
ing right or left.
EN
DE
IT
Bekijk gratis de handleiding van Whirlpool WHD2 6553 X5E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WHD2 6553 X5E |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 5712 MB |
