Whirlpool WFW5720RR handleiding

29 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 13 van 29
13
Connect Inlet Hoses
IMPORTANT: To avoid leaks, check that your water inlet hoses
have flat washers at both ends. Washer must be connected to
water faucets with new inlet hoses with flat washers (not
provided). Do not use old hoses. Do not use hoses without
washers.
7. Insert new flat washers
8. Connect inlet hoses to water faucets
IMPORTANT: Do not overtighten or use tape or sealants on
valve when attaching to faucets or washer. Damage can
result.
Attach the hose labeled hot to hot water faucet. Screw on
coupling by hand until it is seated on washer. Use adjustable
pliers to tighten couplings an additional two-thirds turn.
Repeat this step with the hose labeled cold for the cold water
faucet. Both hoses must be connected for washer to work
properly.
HELPFUL TIP: Make note of which hose is connected to hot
water to help in attaching hoses to washer correctly. In most
standard configurations, hoses will cross over each other
when attached correctly.
9. Clear water lines
Run water for a few seconds through hoses into a laundry
tub, drainpipe, or bucket to avoid clogs. Water should run until
clear.
10. Connect inlet hoses to washer
IMPORTANT: To reduce risk of hose failure, replace the
hoses every 5 years. Record hose installation or replacement
dates for future reference.
Do not overtighten hose or use tape or sealants on the
valve. Damage to the valves can result.
Periodically inspect and replace hoses if bulges, kinks,
cuts, wear, or leaks are found.
Attach hot water hose to hot water inlet valve. Screw
coupling by hand until it is snug. Use adjustable pliers to
tighten couplings an additional two-thirds turn. Repeat with
cold water inlet valve.
11. Check for leaks
Slowly turn on water faucets to check for leaks. A small
amount of water may enter washer. It will drain later.
12. Secure drain hose
Secure drain hose to laundry tub leg, drain standpipe, or inlet
hoses for wall standpipe with cable tie or beaded tie strap.
It is the responsibility of the installer to install and secure the
drain hose in to the provided plumbing/drain in a manner that
will avoid the drain hose coming out of or leaking from the
plumbing/drain.

Bekijk gratis de handleiding van Whirlpool WFW5720RR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkWhirlpool
ModelWFW5720RR
CategorieWasmachine
TaalNederlands
Grootte7893 MB