Handleiding
Je bekijkt pagina 10 van 30
CLEANING AND MAINTENANCE
Make sure that the oven has cooled down before
carrying out any maintenance or cleaning.
Do not use steam cleaners.
Wear protective gloves.
Do not use wire wool, abrasive scourers or abrasive/
corrosive cleaning agents, as these could damage the
surfaces of the appliance.
The oven must be disconnected from the mains
before carrying out any kind of maintenance work.
EXTERIOR SURFACES
• Clean the surfaces with a damp microfibre cloth.
If they are very dirty, add a few drops of pH-neutral
detergent. Finish off with a dry cloth.
• Do not use corrosive or abrasive detergents. If
any of these products inadvertently comes into
contact with the surfaces of the appliance, clean
immediately with a damp microfibre cloth.
INTERIOR SURFACES
• After every use, leave the oven to cool and then
clean it, preferably while it is still warm, to remove
any deposits or stains caused by food residues To
dry any condensation that has formed as a result
of cooking foods with a high water content, let the
oven to cool completely and then wipe it with a
cloth or sponge.
• Activate the “Hydro Self Clean” function for
optimum cleaning of the internal surfaces.
• Clean the glass in the door with a suitable liquid
detergent.
ACCESSORIES
Soak the accessories in a washing-up liquid solution
after use, handling them with oven gloves if they
are still hot. Food residues can be removed using a
washing-up brush or a sponge.
The Crisp plate should be cleaned using water and
a mild detergent. For stubborn dirt, rub gently with
a cloth. Always leave the Crisp plate to cool down
before cleaning.
TROUBLESHOOTING
Problem Possible cause Solution
The oven is not
switching on.
Power cut.
Disconnection from the mains.
Check for the presence of mains electrical
power and whether the oven is connected
to the electricity supply.
Turn off the oven and restart it to see if the
fault persists.
The oven makes
noises, even when it is
switched off.
Cooling fan active.
Open the door or hold and wait until the
cooling process has finished.
The display shows the
letter “F” followed by a
number or a letter.
Software fault.
Contact the Call Center and state the
number following the letter “F”.
The oven does not
heat up.
When “DEMO” is “On” all commands
are active and menus available but the
oven doesn’t heat up.
DEMO appears on display every 60
seconds.
Access “DEMO” from “SETTINGS” and select
“Off ”.
Policies, standard documentation and additional product information can be found by:
• Using the QR code in your appliance
• Visiting our website docs . whirlpool . eu / docs
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When contacting our After-
sales Service, please state the codes provided on your product's identication plate.
®/TM/© 2024 Whirlpool. Produced under license.
400020001541
Bekijk gratis de handleiding van Whirlpool WCW64HUSX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WCW64HUSX |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 4486 MB |
