Handleiding
Je bekijkt pagina 17 van 80
Before to run the descaling phase, the appliance will
check if some residual water is contained into the
boiler, and a Drain cycle could be performed, if
needed. In this case, you will have to empty the
drawer after the Drain cycle, before continuing with
the Descale Phase.
Please note: to ensure that the water is cold, it is not
possible to perform this activity before 30 minutes have
elapsed from the last cycle (or the last time the product
was powered). During this waiting time, the display will
show the following feedback “WATER IS HOT”.
» PHASE 1/2: DESCALING (70 MIN)
1+
= 75 g
+2
250 ml
3
When display will show <ADD 0.25 L OF SOLUTION>,
please pour the descaling solution in the drawer. For
best results in descaling, we recommend filling the
tank with a solution composed of 75 g of the specific
WPRO product and 250 ml of drinking water. WPRO
descaler is the suggested professional product for the
maintenance of the best performance of your steam
function in the oven. For orders and information
contact the after sales service.
Whirlpool will not be held responsible for any
damage caused by the use of other cleaning products
available on the market.
Once the descaling solution is poured inside the
drawer, press
to start the main descaling process.
The descaling phases do not need you to stay in front
of the appliance. After each phase is completed, an
acoustical feedback will be played and the display
will show instructions to proceed with the next
phase.
Once the descaling phase has been completed, the
boiler will be drained: the descaling solution used
during this phase will be poured into the extractable
drawer.
» PHASE 2/2: RINSING (30 MIN.)
To remove descale residuals from the drawer and
the steam circuit, rinse cycle has to be done. When
display shows <ADD 0.25 L OF WATER> fill the tank
with 0,25 L of drinking water, then press
to start
the rinsing. Do not turn off the oven until all the steps
required by the function have been completed.
Please note: if needed from the system, it could be
requested to emty the drawer and to repeat this
operation.
When Descale procedure is completed, it is suggested
to dry the cavity from potential water residuals. It will
be then possible to use all the steam functions.
Please note: during the Descale cycle, some noise could
potentially be heard since the oven pumps are activated
in order to guarantee the optimal descale efficiency.
Once the maintenance cycle has started, do not remove
the drawer unless requested by the appliance.
Please note: After the boiler gets filled by the descaling
solution and the display shows “DESCALING PHASE 1/2”,
the cycle should not be interrupted and/or the door
opened, otherwise the entire descaling cycle must be
repeated before being able to run any steam function.
Bekijk gratis de handleiding van Whirlpool WCT9A9PHTSB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | WCT9A9PHTSB |
| Categorie | Oven |
| Taal | Nederlands |
| Grootte | 12803 MB |
