Handleiding
Je bekijkt pagina 25 van 112
EN / 25
• The electric cable must not be crushed,
folded, jammed or touch hot parts of the
product. If the electric cable is damaged,
it must be replaced by a qualified electri-
cian. Otherwise there is an electric shock,
short circuit or fire hazard!
• The mains supply data must correspond
to the data specified on the type label of
the product. The rating plate is either
seen when the door or the lower cover of
the appliance is opened or it is located at
the rear wall of the appliance depending
on the appliance type.
• and must use the appropriate socket out-
let/line and plug for oven. In case of the
product's power limits are out of current
carrying capability of plug and socket
outlet/line, the product must be connec-
ted through fixed electrical installation
directly without using plug and socket
outlet/line.
• If the product will be connected directly
to the supply power: If it is not possible
to disconnect all poles in the supply
power, a disconnection unit with at least
3 mm contact clearance (fuses, line
safety switches, contactors) must be
connected and all the poles of this dis-
connection unit must be adjacent to (not
above) the product in accordance with
IEE directives. Failure to obey this in-
struction may cause operational prob-
lems and invalidate the product warranty.
• Additional protection by a residual cur-
rent circuit breaker is recommended.
If the product is produced with cable and
without plug:
Connect the cord of product to supply
power as identified below:
Make the terminal block connection of your
product according to the connection/phase
information on the product type label.
If your supply cord type is 3-conductor type,
for 1-phase connection:
- Brown = L (Phase)
- Blue = N (Neutral)
- Green/Yellow wire = (E) (Earthing)
4.3 Gas connection
• There is risk of explosion, fire and toxica-
tion could be occur if installation, repair
or connection are made from unauthor-
ised/unlicensed/ unqualified person or
technician.
• Before placing the product, make sure
that the local distribution conditions (gas
type and pressure) and whether the
product gas setting complies with these
conditions. Gas adjustment conditions
and values of the product are located on
the labels (or type label).
• If your country code is not on the label,
follow the local technical instructions for
your country for gas connection and con-
version.
• Product can be connected to gas supply
system only by an authorised/licensed/
qualified person or technician.
• Manufacturer shall not be held respons-
ible for damages arising from procedures
carried out by unauthorised/unlicensed/
unqualified person or technician.
• Before starting any work on the gas in-
stallation, disconnect the gas supply.
There is the risk of explosion!
EN
PL
Bekijk gratis de handleiding van Whirlpool W6G8LSSAWTA, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Whirlpool |
| Model | W6G8LSSAWTA |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 12451 MB |
