Whirlpool GMT 6422 OW handleiding

Fornuis

Whirlpool

80 pagina's

PDF beschikbaar

Handleiding

INSTALLATION CLASS 3

TECHNICAL INFORMATION FOR THE INSTALLER

• Use protective gloves for handling, preparing and installing the product.

• This product can be embedded in a worktop 20 ÷ 40 mm thick.

• If there is no oven beneath the hob, insert a separator panel that has a surface at least equal to the opening in the work surface. This panel must be positioned

at a maximum distance of 150 mm below the upper surface of the work surface but, in no case less than 20 mm from the bottom of the hob. In the case that

you intend to install an oven beneath the hob, make sure that it is equipped with a cooling system.

DIMENSIONS AND DISTANCES TO BE MAINTAINED

0-8 mm

475 - 477 mm

555 - 557 mm

min. 55 mm

20-40 mm

39 mm

510 mm

600 mm

Min. 200 mm

Min. 650 mm

Min. 420 mm

Min. 600 mm

NOTE: Kitchen cabinets adjacent to the appliance and taller than the top of the hob must be at least 200 mm from the edge of the hob.

Hoods must be installed according to their relative installation instruction manuals and at a minimum distance of 650 mm from the hob (see gure).

Place the wall cabinets adjacent to the hood at a minimum height of 420 mm from the hob (see gure).

If the hob is installed beneath a wall cabinet, the latter must be situated at a minimum of 700 mm above the hob.

ASSEMBLY

After cleaning the perimeter surface, apply the supplied gasket to the hob as shown in the gure.

Position the hob in the worktop opening made respecting the dimensions indicated in the Instruction.

NOTE: the power supply cable must be long enough to permit its upward extraction.

To secure the hob, use the brackets (A) provided with it. Fit the brackets into the relevant bores shown by the arrow and fasten them by means of their screws in

accordance with the thickness of the worktop (see the following gures).

20 mm 40 mm

30 mm

GAS CONNECTION

• Connect elbow (A)* or (B)* supplied with to the hob inlet main pipe and interpose the washer (C) supplied, in compliance with

EN 549.

* Use elbow (A) for France and elbow (B) for all other destinations.

• After connection to the gas supply, check for leaks with soapy water. Light up the burners and turn the knobs from max

position

to minimum position to check ame stability.

ELECTRICAL CONNECTION

Ground cable

(yellow / green)

Bekijk gratis de handleiding van Whirlpool GMT 6422 OW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.