Westinghouse W1.7WCAC handleiding
Handleiding
Je bekijkt pagina 6 van 41
6
|
English
• Release the switch trigger and wait until the tool stops completely.
• Disconnect this tool from the power supply.
• Thoroughly inspect the tool for any damage.
• Repair any damage before restarting and operating the tool.
z Do not lift or hold this tool above the ground when operating. This can result in loss of control and possible serious personal injury.
Only operate this tool in accordance with the operating instructions provided in this manual.
z Keep the guards in place and in working order.
z Disconnect the plug from power sources when not in use, before servicing, and when changing accessories.
z Follow all instructions for lubricating and changing accessories.
z Retain these instructions. Refer to them frequently and use them to instruct others who may use this tool.
SAFETY
ELECTRICAL SAFETY
DOUBLE-INSULATED APPLIANCES
In a double-insulated appliance, two systems of insulation are
provided instead of grounding. No grounding means is provided
on a double-insulated appliance, nor should a means for grounding
be added to the appliance. Servicing a double-insulated appliance
requires extreme care and knowledge of the system, and should
be performed only by qualified service personnel.
Replacement parts for a double-insulated appliance must be
identical to the parts they replace. A double-insulated appliance is
marked with the words“Double Insulation” or “Double Insulated.”
The symbol (square within a square) may also be marked on the
appliance.
This electric tool is double-insulated, eliminating the need for a
separate grounding system. Use only identical replacement parts.
Read the instructions before servicing double- insulated appliances.
Use this tool only as described in this manual.
EXTENSION CORDS
See Figure 1.
When using a power tool at a considerable distance from a power
source, be sure to use an extension cord that has the capacity to
handle the current the product will use. An undersized cord will
cause a drop in line voltage. This can result in overheating and
loss of power. Use the chart to determine the minimum wire size
required in an extension cord. Only round jacketed cords listed by
Underwriter’s Laboratories (UL) should be used.
When working outdoors with a product, use an extension cord that
is designed for outside use. This type of cord is designated with
“WA” or “W” on the cord’s jacket. Be sure to use a heavy guage
(A.W.G.) wire for the product based on the chart below. If in doubt,
use the next heavier gauge. (smaller gauge numbers equal heavier
cords). Using an undersized cord will cause a drop in line voltage
and result in loss of power and overheating.
**Ampere rating (on product data plate)
0-2.0 2.1-3.4 3.5-5.0 5.1-7.0 7.1-12.0 12.1-16.0
Cord Length
Wire Size (A.W.G.)
25’ 16 16 16 16 14 14
50’ 16 16 16 14 14 12
**Used on 12 gauge – 20 amp circuit.
NOTE: AWG = American Wire Gauge
Before using any extension cord, inspect it for loose or exposed
wires and cut or worn insulation.
It is possible to tie the extension cord and power cord in a knot to
prevent them from becoming disconnected during use. See Figure
1. Make the knot. Connect the plug end of the power cord into the
receptacle end of the extension cord. This method can also be used
to tie two extension cords together.
WARNING
Keep the extension cord clear of the
working area. Position the cord so that it will not get caught
on lumber, tools, or other obstructions while working with
a power tool. Failure to do so can result in serious personal
injury.
WARNING
Inspect extension cords before each
use. If damaged, replace the extension cord immediately.
Never use the product with a damaged cord. Contact with the
damaged area could cause an electrical shock and result in
serious injury.
Bekijk gratis de handleiding van Westinghouse W1.7WCAC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Westinghouse |
| Model | W1.7WCAC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3886 MB |
