Westinghouse 73207LE handleiding

Ventilator

Westinghouse

20 pagina's

PDF beschikbaar

Handleiding

ETL-ES-Contempra-Damp-WH25

TROUBLESHOOTING

GUIDE

If you have difficulty operating your new ceiling fan, it may be the result of incorrect assembly, installation, or

wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults,

please check this Trouble Shooting Chart. If a problem cannot be remedied, please consult with your qualified

electrician and do not attempt any electrical repairs yourself.

1 Figure

Touching

Ceiling

:Blade Tip Down

Fan Blade

:Blade Tip Up

Fan Blade

Blade Brackets

TROUBLE SUGGESTED REMEDY

1. If fan does not start: 1. check main and branch circuit fuses or circuit breakers.

2. check wire connections as performed in step #6 or #7 of installation.

CAUTION: Make sure main power is turned off.

3. Make sure forward/reverse switch is firmly in up or down position.

Fan will not operate when switch is in the middle.

4. If the fan still will not start, contact a qualified electrician.

Do not attempt to troubleshoot internal electrical connections yourself.

2. If fan sounds noisy: 1. check to make sure all screws in motor housing are snug (not over tightened).

2. check to make sure the screws which attach the fan blade holder to the motor are tight.

3. Some fan motors are sensitive to signals from Solid State variable speed controls.

DO NOT USe a Solid State variable speed control.

4. Allow “break-in” period of 24 hours. Most noises associated with a new fan will disappear after this period.

5. Allow “break-in” period of 24 hours. Most noises associated with a new fan will disappear after this period.

3. If fan wobbles: All blades are weighed and grouped by weight. Natural woods vary in density which could cause the fan to wobble even though all blades

are weight-matched. The following procedures should eliminate most of the wobble. check for wobble after each step.

1. check that all blades are screwed firmly into blade holders.

2. check that all blade holders are tightened securely to motor.

3. Make sure that canopy and mounting bracket are tightened securely to ceiling joist.

4. Most fan wobble problems are caused when blade levels are unequal. Check this level by selecting a point on the ceiling above the

tip of one of the blades.Measure this distance as shown in Figure 1. Keeping measure within 3mm, rotate the fan until the next blade

is positioned for measurement. Repeat for each blade. If all blade levels are not equal, you can adjust blade levels by the following

procedure. To adjust a blade tip down, insert a washer (not supplied) between the blade and blade holder at the screw closest

to the motor (Figure 2). To adjust a blade tip up, insert washer (not supplied) between the blade and blade holder at the two screws

farthest from the motor (Figure 2).

5. If blade wobble is still noticeable, interchanging two adjacent (side by side) blades can redistribute the weight and possibly result in

smoother operation.

4. If light does not work: 1. check to see that the wire connections in the switch housing are connected.

2. check for faulty light bulbs.

3. If light kit will still not operate, contact a qualified electrician for assistance.

Bekijk gratis de handleiding van Westinghouse 73207LE, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.