Warmup Tectora handleiding
Handleiding
Je bekijkt pagina 4 van 28
4
Please also read the full instructions that follow this section.
Installation summary
• Begin installing the diuser plates
in the corner of the room, 150mm
o the wall for pipe bends.
• Staple the diuser plates to the
joists every 150mm.
• Install the service pipe in the joist
space using Warmup pipe bend
supports and Warmup clips to
secure to a thinner insulation
layer.
• Insulate the joist space with rigid
insulation in line with building
regulations.
• Rigid insulation must be installed
with its top surface 19mm below
the top of the joists, such that
it properly supports the Tectora
diuser plate and the installed
pipe.
• Install the sensor centrally onto a
joist creating a notch in the joist
for the sensor tip.
• The diuser plates where the
sensor is to be located must be
cut back 25mm on all sides.
3 4
5 6
• Tectora must only be installed on
joists at 400mm centres.
• Ensure the joists are level and
even, clear of debris and without
any surface deviations such as
knots or nails.
• 25 x 25mm battens must be
installed in the joists to support
the rigid insulation layer.
• Drill/notch the joists in line with
building regulations.
1 2
Bekijk gratis de handleiding van Warmup Tectora, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | Tectora |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8419 MB |
