Warmup Nexxa handleiding
Handleiding
Je bekijkt pagina 16 van 36
16
Step 4 - Lay the pipe
• It is recommended to use the spiral pattern to achieve an even surface
temperature and high heat output.
• The rst loop should be laid around the perimeter of the room, then
working inwards towards the centre at double the intended pipe
spacings.
• Once you reach the centre, work back out, completing the spiral at the
intended pipe spacing.
4A
Beginning from the manifold location, following the projects working
drawings, begin laying the pipe, maintaining a gap of half the design pipe
spacing around the perimeter of the room.
4B
• Where it is not practical to use the spiral pattern, a double meander
pattern can be used, providing a more even surface temperature and
higher heat output than a single meander pattern.
• The pipe should be laid referring to the working drawings, alternating
the rst run between 3 times and 1 times the design pipe spacing, before
working back to the manifold location.
Bekijk gratis de handleiding van Warmup Nexxa, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Warmup |
| Model | Nexxa |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 8567 MB |
