Wagner SprayPack 18V handleiding
Handleiding
Je bekijkt pagina 31 van 88
31
SprayPack 18V
EN
Preparing the paint
To avoid rapid blockage of the nozzle and lter, we
recommend stirring and sieving the paint well before
spraying. Follow the material manufacturer's instructions.
Select tip and gun lter
The rst digit of the tip number species the spraying
angle: e.g. 4xx = 40°
The second and third digits specify the tip size:
e.g. x10 = 0.010 inches
The appropriate gun lter must be selected depending
on the tip size:
Tip Size Filter
x08, x10, x11, x12, x13, x14 red
x15 yellow
x17 white
Locking and unlocking the gun
WARNING
Always lock the trigger o when attaching the spray tip
or when the spray gun is not in use.
Locking the gun
Push in the trigger lock from
left to right, when looking at
the rear of the gun.
Unlocking the gun
Push the trigger lock from
right to left, when looking at
the rear of the gun.
Earthing
WARNING
When processing materials containing solvents, the
appliance must be earthed.
1) Remove the earth screw and screw the enclosed earth
cable to the side of the appliance.
2) Attach the earth clamp to a suitable metal installation
(e.g. water pipe, radiator, garden fence).
Pressure relief procedure
WARNING
Be sure to follow the pressure relief procedure when
shutting the unit o FOR ANY PURPOSE. This procedure
is used to relieve pressure from the spray hose.
1)
Lock the spray gun o and
ip the ON/OFF switch to the
OFF position.
O
2) Turn the PRIME/SPRAY knob
to PRIME.
3) Unlock the spray gun and
then trigger it onto a scrap
piece of wood or cardboard.
4) Lock the spray gun.
Dry running
CAUTION
Operation without liquid leads to increased wear and
damages the pump.
Never allow the device to run dry for more than 30
seconds.
One cause of blockages can be a clogged gun or inlet
lter/suction lter. Therefore, check and clean the lters
regularly.
Relling the container / bleeding the pump
CAUTION
If the paint in the container runs out, it may be that air
is being aspirated into the system. When relling, the
pump must be bled as described below in order to avoid
dry running.
1) Switch the pump o
immediately.
2) Rell the container.
O
3) Turn the PRIME/SPRAY knob
to PRIME.
4) Switch the pump back on
and wait until the paint is
owing out of the return
hose.
5) Turn the PRIME/SPRAY
switch to the SPRAY
position and carry on
working.
IMPORTANT INFORMATION
Bekijk gratis de handleiding van Wagner SprayPack 18V, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wagner |
| Model | SprayPack 18V |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 17840 MB |
