Wachendorff WDGA 58F handleiding
Handleiding
Je bekijkt pagina 70 van 79
Technical Manual
WDGA with EtherNet/IP
6 - Commissioning
© Wachendorff Automation GmbH & Co. KG
62
Repeat this for all the tags you have created. Make sure that you assign the parameters
correctly:
Attribut-ID
Message
Quelle
Bytes
14 (Scaling)
Send_MSG_Scaling
Scaling_toggle
1
16 (MUPR)
Send_MSG_MUPR
MUPR_value
4
17 (TMR)
Send_MSG_TMR
TMR_value
4
19 (Preset)
Send_MSG_Preset
Preset_value
4
Table 6.1: Configurations
After you have created and configured everything, your program should look like the
one shown below.
Figure 6.35: Configure main program
Now go online with the controller and download the program you just edited. Then
navigate back to the "Program Parameters and Local Tags" tab. Now enter the values
you want.
For example, if you want to activate the scaling, define a shaft revolution with 0.1°, set
the total measuring range to 10 revolutions and have the position value start at 0, then
make the following settings.
Figure 6.36: Parameters and tags
Now switch back to your main program and activate the "Execute" closer by selecting
it and pressing Ctrl + T.
Bekijk gratis de handleiding van Wachendorff WDGA 58F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Wachendorff |
| Model | WDGA 58F |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11849 MB |
