Vulcan VSC48 handleiding
Handleiding
Je bekijkt pagina 5 van 25
II. f - PLACING EQUIPMENT ON TOP OF UNIT:
Equipment may be placed on top of your Traulsen equip-
ment stand. A stainless steel worktop, provided standard
is required on cabinets being used to support equipment
weighing in excess of 100 lbs. or producing heat in excess
of 140°F to the top surface. Refer to below chart to deter-
min Maximum Top Load Capacity for your unit.
Model Max Top Load
Capacity lbs.
TE036HT 625
TE048HT 625
TE060HT 1200
TE065HT 1200
TE072HT 1200
TE084HT 1500
TE096HT 1500
TE110HT 1500
TE125HT 2000
TE139HT 2000
IV. OPERATION
IV. a - REFRIGERATORS:
Refrigerators do not require manual defrosting. During
normal operation, a refrigerator continuously circulates
above freezing cabinet air through the coil. A compressor
“OFF” cycle occurs every 2 1/2 Hours for 20 minutes to melt
any frost which may accumulate on the coil during the
compressor “ON” cycle. The control will read “dEF” and
the green water drop will be illuminated. With standard
holding refrigerators, high relative humidity is also main-
tained to prevent dehydration of stored product.
V. a - CLEANING THE CONDENSER/FILTER:
The most important thing you can do to insure a long,
reliable service life for your Traulsen is to regularly clean
the condenser coil and or lter if provided.
The microprocessor control will notify you through a
“CLN-FIL” message when the condensing temperature of
the refrigerator reaches 140 degrees F or greater. If the
condensing temperature reaches 160 degrees F the com-
pressor will automatically turn o . When the temperature
drops below 140 degrees F the compressor will restart
and when the temperature drops below 120 degrees F
the alarm will reset.
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY
BEFORE CLEANING ANY PARTS OF THE UNIT.
To clean the condenser/lter, rst disconnect electrical
power to the cabinet and remove the front louver as-
sembly. To do so, place hands under the louver panel and
pull out and up to get louver panel o bracket of the unit.
See diagram below.
Proceed to vacuum or brush any dirt, lint or dust from the
nned condenser coil/lter, the compressor and other
cooling system parts. If signicant dirt is clogging the
condenser ns or lter, use compressed air to blow this
clear.
To replace the louver assembly reverse the process.
-3-
III. INSTALLATION (continued)
FREEZER
SET
INTELA-TRAUL
°F °C
V. CARE & MAINTENANCE
Bekijk gratis de handleiding van Vulcan VSC48, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | VSC48 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3100 MB |
