Vulcan VR36 handleiding
Handleiding
Je bekijkt pagina 6 van 25
-4-
V. b - REPLACING THE GASKETS:
To remove the gasket to be replaced, grasp it rmly by
one corner and pull it out. Before attempting to install a
new gasket, both the unit and the gasket itself must be at
room temperature. Insert the four corners rst by using
a rubber mallet (or hammer with a block of wood). After
the corners are properly inserted, work your way towards
the center from both ends by gently hitting with a mallet
until the gasket is completely seated in place (see gure
5 for proper gasket placement).
NOTE: The gasket may appear too large, but if it is in-
stalled as indicated above it will slip into place.
V. c - CLEANING THE CABINET SURFACES:
WARNING: DISCONNECT ELECTRICAL POWER SUPPLY
BEFORE CLEANING ANY PARTS OF THE UNIT.
Exterior stainless steel should be cleaned with warm wa-
ter, mild soap and a soft cloth. Apply with a dampened
cloth and wipe in the direction of the metal grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the surface.
Do NOT use cleansers containing chlorine, such as bleach,
this may promote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit with
water, containing chlorinated cleansers, when mopping
the oor around the unit.
For stubborn odor or spills, use baking soda and water
(mixed to a 1 tbsp baking soda to 1 pint water ratio).
A stainless steel polish is recommended for shining of
unit.
Fig. 5
SIDE DRAWER PANEL
GASKET ASSEMBLY
VERTICAL GASKET
RETAINER
VI. a - REMOVING THE DRAWERS AND
FRAME MODULE:
Remove the drawer (s) from the drawer frame by lifting
up on the drawer and pull out.
Once the drawer(s) have been removed, the drawer
frame module can also be removed by loosening the
black front and back clamping knobs (2 of each) located
on the cross rail locks and liner locks. Slide the front
cross rail locks towards the center of the drawer frame
module and allow the liner locks to drop down from the
top of the liner. Pull the door frame module forward, tip
forward and pull out. The entire frame assembly is now
free to slide out of the cabinet.
Front Clamping
Knobs
Front Cross
Rail Locks
Back Clamping
Knobs
V. CARE & MAINTENANCE-(continued) VI. DRAWERS
Bekijk gratis de handleiding van Vulcan VR36, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | VR36 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3100 MB |
