Vulcan VCH88 handleiding
Handleiding
Je bekijkt pagina 11 van 44
VCH & VRT SERIES OVENS F-41162 (02-16)
10
PRE-PROGRAMMED CYCLES
The Oven can be programmed for 9
cooking/holding cycles. (P-1 thru P-9)
To program each cycle, P-1 through P-
9, use the following instructions.
PROGRAMMING:
From the “Idle State” while the Time is
blinking:
1. Press and Hold the ADJ/SET
Button for 3 seconds. The time
will no longer blink.
The Cabinet Temp. will display
“P-0” and is blinking. Turn
Adj/Set knob to display P-1, go to
step 3.
2. If P-2 through 9 is the desired
cycle, Rotate the ADJ/SET
Knob to the desired pre-
programmed cycle.
3. Press and Hold the ADJ/SET
Knob for 3 seconds.
Time will start blinking.
4. Rotate the ADJ/SET Knob to
desired time.
5. Press the ADJ/SET Knob to
accept the time.
Cook Temp. will start blinking.
6. Rotate the ADJ/SET Knob to
desired cooking temperature.
7. Press the ADJ/SET Knob to
accept Cook Temp.
Hold Tem. will start blinking.
8. Rotate the ADJ/SET Knob to
desired holding temperature.
9. Press the ADJ/SET Knob to
accept Hold Temp.
10. Push Start Button
OPERATING:
1. Switch ON/OFF Switch to ON.
During the “Idle State/Time is blinking”:
2. Press and Hold the ADJ/SET
Knob for 3 seconds. The time
will no longer blink.
The Cabinet Temp. will display
“P-1” and is blinking.
3. Rotate ADJ/SET Knob to
desired pre-programmed cycle:
P-1 through 9.
4. Press Start Button.
You can push the ADJ/SET Knob any
time to abort the cycle and return to idle.
Bekijk gratis de handleiding van Vulcan VCH88, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | VCH88 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 23870 MB |
