Handleiding
Je bekijkt pagina 11 van 20
- 11 -
HOT TOPS
The hot tops are coated with oil as a rust inhibitor. Remove this film when the hot tops are being
cleaned prior to its first cooking use. Heat the hot tops to 200-300°F to loosen and melt the coating,
then clean the surface with a non-corrosive, grease dissolving commercial cleaner, following the
manufacturer’s directions. Rinse thoroughly and wipe dry with a soft clean cloth.
The hot tops are steel, but the surface is soft and can be scored or dented by
careless use of spatulas or scrappers. Be careful not to dent, scratch or gouge the hot tops.
INSTALLATION OF GRIDDLE/BROILER BRICKS
1. Remove six 5 ¼‖ x 2 ¼‖ (133 x 57 mm) and six 5 ¼‖ x 5
1
∕
16
‖ (133 x 129 mm) bricks from the
shipping box packaged in the oven cavity.
2. Install the 5 ¼‖ x 2 ¼‖ (133 x 57 mm) bricks to the left and right hand sides of the broiler by inserting
the bricks individually through the front opening in the broiler. Angle the brick sideways for easy fit
between the burner edges. Set the bricks flat in place, resting on the broiler side and burner edges.
Push each brick as far to the rear of the broiler as possible to ensure easy fit of the last brick.
3. Install the remaining six 5 ¼‖ x 5
1
∕
16
‖ (133 x 129 mm) bricks to the center section as described in
step 2. Place the bricks on the center burner edges only.
PLUMBING
A preset gas pressure regulator and plumbing fittings are shipped uninstalled. This regulator must be
installed by an authorized service person before the unit is placed into operation. See full unit data plate
located on the rear of the range, or the secondary data plate, riveted to the kick panel, for pressure
regulator setting information. If a manometer is being used, utilizing one of the available pressure taps
in the manifold, the manifold pressure with one burner on should be ± 0.3" W.C. of the value indicated
on the rating plate.
1. Refer to the Modular Range Field Plumbing Reference Guide (p/n 921861) shipped with the
regulator and fittings for 48", 60", and 72" ranges.
2. Cover the pipe threads with pipe joint compound resistant to propane gases.
3. For 12", 24", and 36" ranges, screw the reducer, pipe nipple, and regulator onto the pipe with the
regulator flow direction arrow pointing towards the back of the unit and the regulator adjustment in
the upright position.
For 48", 60", and 72" ranges, follow the assembly steps as detailed in the Modular Range Field
Plumbing Reference Guide.
4. The pressure regulator must be mounted horizontally to ensure the proper preset outlet pressure. If
mounted in any other direction, the outlet pressure must be rechecked and possibly reset. A leak
limiter is supplied with every regulator to allow excess gas pressure to escape. Do not obstruct the
limiter or the gas regulator, as obstruction may cause the regulator to malfunction.
Bekijk gratis de handleiding van Vulcan 72SS-6B36GN, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | 72SS-6B36GN |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4983 MB |
