Handleiding
Je bekijkt pagina 8 van 20
- 8 -
obstruction of the flue will result in voiding of warranty. It is recommended that the flue gases be
ventilated to the outside of the building through a ventilation system installed by qualified personnel.
From the termination of the flue to the filters of the hood venting system, a minimum clearance of 18"
(457 mm) must be maintained. Information on the construction and installation of ventilating hoods
may be obtained from the standard for "Vapor Removal from Cooking Equipment," NFPA No. 96 (latest
edition), available from the National Fire Protection Association, Batterymarch Park, Quincy, MA 02269.
LEVELING
To level the range, place a carpenter's level on the range top and check leveling of the unit side to side
and front to rear. Achieve leveling by turning each foot section of the unit's leg as needed. Turning the
foot in a counter clockwise direction will increase height and clockwise will decrease.
BULLNOSE INSTALLATION
1.) Remove Grate Castings along the front of edge of the Range.
2.) Slide Bullnose over mounting bracket and align with Range so that it is not offset in either
direction.
3.) Start screw at one end of the Range, do not tighten completely.
4.) Going across the width of the Range install the next screw, as shown in Figure 2, set the
alignment and tighten screw completely.
5.) Install the remaining screws and tighten all screws completely.
Condiment Rail
(Accessory)
Cutting Board
(Accessory)
Towel Bar
(Accessory)
Standard
Bullnose
Remove Grates
on Gas Range
Figure 1
Bekijk gratis de handleiding van Vulcan 72RC-8B24GP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | 72RC-8B24GP |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4983 MB |
