Handleiding
Je bekijkt pagina 18 van 20
- 18 -
General Cleaning
Use ordinary soap or detergent and water for routine cleaning of stainless steel. To prevent water spots
and streaks, rinse thoroughly with warm water and wipe dry with a soft clean cloth. The addition of a
rinsing agent will also help prevent spotting. Do not pressure wash any portion of the range.
Fingerprints
Fingerprints are sometimes a problem on highly polished surfaces of stainless steel. They can be
minimized by applying a cleaner that will leave a thin oily or waxy film. To use these cleaners, simply
wipe on and remove excess with a soft dry cloth. After using, subsequent fingerprints will usually
disappear when wiped lightly with a soft cloth or with a cloth containing a little of the cleaner. If the
surface is especially dirty to start, wash first with soap or detergent and water.
Heat Tint
Straw-colored or slightly darkened areas may appear on stainless steel in and around ovens and
ranges where temperatures reach 500°F (260°C) or more. This "heat tint" is caused by a slight
oxidation of the stainless steel and is not harmful. To control or minimize this condition, never use
more heat than is absolutely necessary.
MAINTENANCE & ADJUSTMENTS
Disconnect the electrical power to the machine and follow Lockout / Tagout
procedures.
LUBRICATION
All moving parts must be checked for wear and lubricated. Contact your local authorized servicer.
Motors in Vulcan Endurance / Wolf Challenger convection ranges are permanently lubricated and
require no additional maintenance.
FLUE
Check the flue when it is cool to be sure it is free of obstructions.
SERVICE AND PARTS INFORMATION
To obtain service and parts information, contact an authorized service agency in your area (refer to our
website, www.vulcanequipment.com or www.wolfequipment.com for a complete listing of authorized
service and parts depots). When calling for service, the following information must be available: model
number, serial number, and gas type. This information can be found on the main data plate, located on
the rear of the unit, or on the secondary plate located inside the lower front kick panel. Lift up and lower
the front kick panel to view the secondary data plate.
PRECAUTIONS
When scraping off heavy deposits of grease or oil from stainless steel equipment, never use ordinary
steel scrapers. Particles of ordinary steel may become embedded in, or lodge on, the surface of the
stainless steel. These will rust, causing unsightly stains and possible contamination of food. If it is
necessary to scrape, use stainless steel, wood, plastic or rubber tools.
Bekijk gratis de handleiding van Vulcan 48SS-8BP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vulcan |
| Model | 48SS-8BP |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 4983 MB |
