Vornado 753 OSC handleiding
Handleiding
Je bekijkt pagina 14 van 17
14 English
1. Press
to power on/off.
2. Select desired fan speed setting by pressing or .
3.
Press to turn Oscillation on/off. Press and hold
for three seconds to change oscillation angle to 180°.
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE AND SOLUTION
Unit fails to power on. Unit is not plugged in. Plug Power Cord into electrical outlet.
Ensure power button has been pressed. Once the power button is pressed the speed setting on the display
should light up.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
Fuse needs to be replaced. See IMPORTANT SAFETY INSTRUCTIONS for how to replace the fuse or contact
Consumer Service.
The outlet is worn or damaged. Try another outlet or contact a qualied electrician.
Unit is not producing
sufcient amount of air.
Unit is set to a low speed setting. Adjust to a higher speed setting.
Airow is blocked. Remove obstruction.
Adjust direction of airow toward the user.
Unit fails to oscillate or
oscillate to full range.
Ensure oscillations is enabled. Press ( ) on unit or remote.
Ensure the space around the unit is free from obstructions.
GFCI has tripped. Under certain conditions, it is possible for a reset GFCI (Ground Fault Circuit Interrupter) outlet to trip when the
user is changing speeds on a Vornado circulator. In this event, change to an outlet that is not connected to a
GFCI device. It could also indicate a weak or defective GFCI outlet. Contact a qualied electrician to check the
GFCI outlet.
Bekijk gratis de handleiding van Vornado 753 OSC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vornado |
| Model | 753 OSC |
| Categorie | Ventilator |
| Taal | Nederlands |
| Grootte | 2280 MB |
