VOREL 78642 handleiding
Handleiding
Je bekijkt pagina 7 van 16
7
GB
OPERATING MANUAL
SPECIFICATION OF THE PRODUCT
Parameter Unit Value
Catalog number 78641 78642
Material Killed steel Killed steel
External dimensions (width x depth x heigth) [mm] 350 x 250 x 250 300 x 200 x 200
Internal dimensions (width x depth x heigth) [mm] 340 x 190 x 240 290 x 140 x 190
Thickness of the door [mm] 4 4
Thickness of the walls [mm] 2 2
Weight [kg] 12.5 8.0
Power supply 4 AA batteries (1.5V)
Locking mechanism. Two cylindrical bolts
Lock Electronic - PIN (a combination of 3-8 digits)
OPENING THE SAFE
Enter the code using numeric keypad and press “A” or “B” button. Factory setting for the code is numbers set 1, 5, 9. Within 5
seconds after you enter the code, you have to turn the key or knob, then pull the door towards yourself.
After each keystroke, the yellow led lights up, and you hear a short beep, it means that the digit is entered into the memory of
microprocessor. After you have entered the correct code, after pressing “A” or “B”, the yellow led will briefl y fl ash, and you will
hear a short sound signal. When after you enter the code, the yellow led will blink longer, and the sound signal will be heard
longer, it means that you have entered an incorrect code. Triple entering of incorrect code results in blocking the possibility toe
enter the code for the next 20 seconds. If the next three attempts will be incorrect, the possibility to enter the code is blocked for
5 minutes.
ATTENTION! For security reasons we recommend that you do not store the recorded opening code near the safe.
CLOSING THE SAFE
Close the safe door, then turn the knob to vertical position.
CHANGE OF THE CIPHER CODE
Open the safe door, then press the red button (10 for III). Onec the yellow LED is on, you need, within 30 seconds, enter a new
code, and then press “A” or “B” button to confi rm the change. The new code must consist of from 3 to 8 digits.
If you enter an incorrect code syntax, the yellow led will fl ash and a beep will be heard. To change the code, repeat the proce-
dure.
THE UNIVERSAL KEY
If the code is forgotten, use the universal key. First you need to remove the protection cover, which is protecting the lock of univer-
sal key. The cover is located next to the knob opening the safe. After removing the cover you should insert the key to lock and turn
it counterclockwise, and then you have to turn the knob opening a safe. Then you can then open the safe door.
Attention! Universal key must not be shut inside the safe.
BATTERY REPLACEMENT
If both green and red leds are on at the same time it means that you need to replace the batteries for power supply. Before closing
the door, you need to check if the batteries have been installed correctly.
There are used batteries of AA type, 4 cells (1,5 V).
You need to replace all four batteries, it is not allowed to use a partially used batteries together with fresh ones. This would shorten
the batteries life. It is also recommended that all batteries origin from one manufacturer.
Bekijk gratis de handleiding van VOREL 78642, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | VOREL |
| Model | 78642 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2039 MB |
