Vollrath CADJ-3 handleiding
Handleiding
Je bekijkt pagina 2 van 12
2 Spring Loaded In-Counter Cup Dispenser Operator’s Manual
3. Rotate the adjustment ring to reveal the mounting holes.
4. Place the tube into the cut mounting hole. Mark the mounting hole
locations.
5. Remove the dispenser from the mounting hole.
6. Pre-drill pilot the pilot holes. Vollrath suggests a ¹⁄₈" (0.125)
diameter pilot hole diameter of ¹⁄₈" (0.125).
7. Insert the dispenser into the cutout hole and align the mounting
holes to the pre-drilled holes.
8. Insert the included screws into the mounting holes. Tighten snuggly.
ADJUST DIAMETER TO FIT CUPS
1. Loosen, but do not remove adjusting ring screws.
2. Rotate the adjusting ring to widen the opening.
3. Insert a short stack of cups into the dispenser.
4. Rotate the adjusting ring until the cups are held in place.
Mounting
hole
Mounting
hole
Mounting hole
Adjusting
Ring Screw
Adjusting
Ring Screw
Adjusting Ring Screw
Bekijk gratis de handleiding van Vollrath CADJ-3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vollrath |
| Model | CADJ-3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4193 MB |
