Vocopro MobileMan handleiding
Handleiding
Je bekijkt pagina 27 van 28
27
Troubleshooting
There is no power (main and subwoofer units)
• Make sure the power cord is firmly connected to the back of the unit and to the power outlet.
• If using a power strip/surge-protector, make sure that it is plugged in and switched on.
• If attempting to run on battery power, the battery may be depleted. Connect the unit to a wall outlet and
recharge the battery.
• Check the fuse, and replace if blown. If the fuse blows again immediately, do not replace it again. Instead,
contact VocoPro technical support.
There is no sound (main unit)
• Make sure the MASTER and CH 1-5/SD VOLUME knobs are set to an audible level.
• Make sure headphones are not connected. Connecting headphones disables the main speaker output.
• If using microphones, make sure they are connected properly and cables are not defective.
• If using an external player, make sure they are connected properly and cables are not defective.
• If an external effects device is connected, make sure it is powered on.
There is no sound (subwoofer unit)
• Check the cable connection to the main unit (see Getting Connected section)
• Make sure the subwoofer main volume is set to an adequate level.
• Adjust the subwoofer frequency. (see Subwoofer Features and Descriptions section)
• If attempting to run on battery power, the battery may be depleted. Connect the unit to a wall outlet and
recharge the battery.
The sound has static
• The signal level from the connected device may be high-level. Set the PAD 30dB button to ON.
No sound output, RF/AF LED(s) are not glowing (Wireless modules)
• Make sure the microphone power switches are set to the ON position.
• Make sure the UHF POWER on the main unit is set to ON.
• Check microphone batteries to ensure that they are providing sufficient power. Replace battery if necessary.
• Make sure antennas are firmly connected and extended to an optimal position.
• If necessary, reduce the distance between the microphones and receiver.
• Talk into the microphone and observe the module’s RF/AF signal LEDs. If they glow, the problem is else
where in the sound system.
Received signal is noisy or contains extraneous sounds with the microphone(s) ON.
• Make sure everything is connected firmly and properly
• Make sure there are no defective cables
• Make sure all of your components are turned on
• Make sure all of the components (amp, mixer, TV, etc.) are set to the proper inputs
There is noise coming from the receiver with the microphones turned OFF.
• This is called interference. Remove local sources of UHF interference, such as lighting equipment. In some
locations this may be unavoidable due to a frequency conflict. Contact VocoPro tech support for more
information.
Momentary loss of sound as microphone(s) are moved throughout the operating range.
• Reposition the receiver, perform a “walkthrough”, and observe the signal strengths. If audio dropouts
persist, mark these “dead spots” in the operating area and avoid them during the performance.
Bekijk gratis de handleiding van Vocopro MobileMan, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vocopro |
| Model | MobileMan |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3196 MB |
