Vocopro HV-1200 handleiding
Handleiding
Je bekijkt pagina 10 van 24
10
Getting Connected cont.
Connecting Power
What you will need:
• Surge Protector (recommended) or power outlet
• Included power cable
To connect Power to the HV-1200
1. Connect one end of the power cable to the rear
panel of the HV-1200.
2. Connect the other end of the power cable to the
power outlet or surge protector.
Connecting Speakers
The Speaker Terminals are located on the rear panel. Be sure to connect the left channel (L), right channel (R), “+”
(red) and “--” (black) properly.
• Before connecting the speakers, make sure that the HV-1200 is
disconnected from the power source.
• Do not let the bare speaker wires touch each other or another metal part
of this unit. This could damage the HV-1200 and/or the speakers.
Preparing the Speaker Cable
You can either use an exposed speaker wire or Banana Plug speaker cable.
Using Exposed Speaker Wire
1. Remove approximately 3/8” (10mm) of insulation.
2. Twist the exposed wires together to prevent short circuits.
3. Loosen the knob on the speaker terminal.
4. Insert the bare wire.
5. Tighten the knob until the wire is secure.
Using Banana Plugs
1. Plug the Banana Connector into the jack,
ensuring that the red and black connections
are aligned.
�
�
Bekijk gratis de handleiding van Vocopro HV-1200, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vocopro |
| Model | HV-1200 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2652 MB |
