Vivolink VLVWIP2000-ENC handleiding
Handleiding
Je bekijkt pagina 18 van 34
12 / 27
12 AUDIO IN/OUT
18
Link Signal
Indicator lamp
(Green)
RS-232
RS-232 serial port, supporting RS-232 command pass-through
and local serial port control.
11
▪ Light on: The network cable is connected normally.
▪ Light off: The network cable is not connected well.
15
17
Data Signal
Indicator lamp
(Yellow)
▪ Light flashing: There is data transmission.
▪ Light off: There is no data transmission.
19 DC 12V
The device can be powered via two methods:
▪ Local DC 12V/2.5A power supply
▪ POE from Network Switch. Device acts as PD mode.
When the Switch supports POE function, DC power supply
is not needed.
14 HDMI OUT
HDMI signal output port, connected to an HDMI display device
such as TV or monitor.
SPDIF IN
S/PDIF signal input port.
13
16
LAN (POE)
FIBER
Connect with optical fiber module, and receive signals from the
Encoder with an optical fiber cable directly or through a Switch.
1G LAN port, connect network Switch to form a distributed
system.
Note: When network switch delivers POE power supply, DC
12V adapter doesn't need to apply on the unit.
AUDIO IN: Analog audio input port, the audio can be transmitted
to Encoder AUDIO OUT in unicast mode (point-to-point direct
connection).
AUDIO OUT: Analog audio output port. It outputs the same audio
of that on HDMI OUT in case audio format is LPCM.
Operation description of the LED screen and CH SELECT buttons (For Decoder).
1, ENC connection: After the system is powered on, the Decoder’s LED screen will
show 000 by default if not set. Directly press the UP/DOWN button to select the
channel ID of the connected Encoder (ID range: 000~762) to complete connection.
2, IP address: Press and hold the UP button for 5 seconds, the Decoder’s LED screen
will show in sequence “IPx", "xxx", "xxx", "xxx", "xxx", which are the IP mode and IP
address of Decoder.
3, Configuration mode: Press and hold UP + DOWN buttons at the same time for 5
seconds, then release to enter the configuration mode with “CFN” displaying on the
LED screen.
JPEG2000 AVoIP Encoder and Decoder
Bekijk gratis de handleiding van Vivolink VLVWIP2000-ENC, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vivolink |
| Model | VLVWIP2000-ENC |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2985 MB |
