Vivolink VLVWIP2000-CTL handleiding
Handleiding
Je bekijkt pagina 9 van 44
8765
No. Function DescriptionName
1 2 4
1 RESET Button
Press and hold this button (about 10 seconds) until Status
LED starts flashing, Controller will be reset automatically.
2
POWER LED
The red LED will light on when the Controller is powered on.
3 STATUS LED
The status LED will flash in yellowish-green every 1 second
until Controller boots up completely and Control LAN is
ready, then it becomes solid.
3/37
3
5.2 Rear Panel
No. Function DescriptionName
1 DC 12V DC 12V/1A power input port.
2
VIDEO LAN
(POE)
100M Video LAN port, supporting POE function.
Note: When POE is enabled, DC 12V/1A power supply is
not required.
3
CONTROL
LAN
The TCP/IP control network port.
4
MCU/Normal
DIP Switch
Normal mode (Default): The RS-232 port is used for serial
port commands control.
MCU mode: The RS-232 port is used for MCU software
upgrade.
5
3-pin Phoenix
Connector
RS-232 serial communication port.
6
6-pin Phoenix
Connector
4 channel I/O level outputs, 1 channel grounding,
1 channel power supply to the outside.
7
IO LEVEL
DIP Switch
Used to control I/O level output and VOUT voltage.
Switch to left: 5V I/O level output, VOUT is 5V.
Switch to right: 12V I/O level output, VOUT is 12V.
8
IR IN
12V IR signal input port.
DC 12V
IO1
IO2
IO3
IO4
5V 12V
IR IN
IO LEVEL
VOUT
NORMAL
MCU
JPEG2000 AVoIP Controller
Bekijk gratis de handleiding van Vivolink VLVWIP2000-CTL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vivolink |
| Model | VLVWIP2000-CTL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4456 MB |
