Vivax HPM-28CH84AERIs R32-1H3 Handleiding (112 Pagina's)

Handleiding

ENG VIVAX

66

Outdoor units should not be installed in locations where exposure to salinity may occur.

Outdoor units should be installed in well-drained, well-ventilated positions.

Outdoor units should be installed in positions that are as close as possible to the heat emitters.

Outdoor units should be installed in positions that are sufficiently close to the desired position of the wired controller

that the controller’s wiring length limitation will not be exceeded.

In systems that are configured to heat domestic hot water and/or include an external backup electric heater, outdoor

units should be installed in positions that are sufficiently close to the domestic hot water tank and/or backup electric

heater that the temperature sensor wiring length limitations will not be exceeded.

Outdoor units should be installed in locations where the noise from the unit will not disturb neighbors.

2.4 Strong Wind Installation

Wind of 5m/s or more blowing against an outdoor unit’s air outlet blocks the flow of air through the unit, leading to

deterioration in unit capacity, accelerated frost accumulation

when in heating mode or domestic hot water mode, and potential

disruption to operation due to increased pressure in the

refrigerant circuit. Exposure to very strong wind can also cause the

fan to rotate excessively fast, potentially leading to damage to the

fan. In locations where exposure to high winds may occur should

take account of the following considerations:

For installation of the outdoor unit in a place where the wind

direction can be foreseen, refer to Figure 3-2.3 and Table

3-2.1 for installation of the unit. Set the outlet side at a right angle to the direction of the wind, refer to Figure 3-2.2.

If turn the air outlet side toward the building's wall, fence or screen. Make sure there is enough room to do the

installation

Figure 3-2.3: Installation room illustration

Tab le 3-2 .1: Ins tal lat ion roo m

requirement (Unit: mm)

Model

A(mm)

4-6KW

ı

300

8-16KW

ı

300

Model

B(mm)

4-6KW

ı

1000

8-16KW

ı

1500

Figure 3-2.2: Strong wind installation direction

Bekijk gratis de handleiding van Vivax HPM-28CH84AERIs R32-1H3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.