Vimar ELVOX 6680/V04 handleiding
Handleiding
Je bekijkt pagina 3 van 40
6680
3/40
GB
OPERATION
The video door entry installation consists of one camera entrance panel with speech unit, one power supply and one or more mo-
nitors. The system can operate with monitors and B/W or colour cameras and with or without conversation privacy.
The power supply is not equipped with intercommunicating section; nevertheless it is possible to set up a monitor and/or inter-
communicating interphones network using switching module type 935A in conjunction with the basic power supply.
When an entrance panel push-button is pressed, the ringtone rings in the corresponding apartment. Almost immediately the image
of the caller appears on the monitor. The coverage area is illuminated by built-in infrared leds when using B/W camera, or by a built-
in white light when using a colour camera.
If desired, the user may simply raise the interphone, communicate with the caller and, if appropriate, activate the door-opener. In
this case, door-opening time may be varied from 1 to 30 seconds using the potentiometer P3.
The system turns itself off automatically after a preset time, adjustable from 30 to 90 seconds using potentiometer P1 inside the
power supply. If the caller presses another user’s push-button, the previously called monitor is automatically disactivated without
waiting for the end of the preset time. When testing the installed system, use trimmer P2 to adjust the optimal volume of the spe-
ech unit. For simultaneous activation of two or more monitors one extra power supply type 6582 must be installed for each ad-
ditional monitor or type 6583 for more monitors. A blocking circuit cuts off power to monitors if the line is overloaded or
short-circuited. The power supply is also equipped with a specific device to eliminate any buzzing on the voice circuit caused by
the use of wires that are too long and/or too thin only in installations with “SOUND SYSTEM” call. Push-buttons with name-tags
are illuminated through output 0-15 on power supply. Up to a maximum number of three 24V 3W bulbs can be connected. An ad-
ditional transformer, type M832 or 0832/030 is required for entrance panels with more bulbs.
Technical specifications of power supply type 6680 - (6680/V03)
type 6680 is the basic power supply for all video door entry systems with SOUND SYSTEM call and is equipped with an electro-
nic double tone generator, which replaces conventional alternative calling with a buzzer or bell. The sound is emitted with two dif-
ferent tones (present on terminals C1-C2) thereby allowing the user to immediately identify the source of the call (main entrance,
gate, garage, etc.). This feature provides economic and practical advantages since the use of several conventional sound emit-
ting systems is no longer required; the signal is emitted from a single loudspeaker in the interphone. In some cases, savings can
be made on the cable routing work requirements for additional bell systems. Manufactured in copolymer class V-0 housing; pre-
set for mounting on cases with 12-Module DIN support or with expanding plugs with screws.
- 230V A.C. 50Hz supply (other voltages on request)
- 60VA maximum absorbed power.
- 18V D.C. 0.8A monitor supply. (90 sec. ON, 90 sec. OFF)
- 13V D.C. 0.3A camera supply. (90 sec. ON, 90 sec. OFF)
- 15V rectified voltage 0.25A continuous duty output for push- push-button illumination (3x24V 3W max)
- 15V A.C. 1A door lock output; intermittent service. (30 sec. ON, 150 sec. OFF)
- Amplified audio door entry system.
- Timer and automatic disconnection device of monitor previously activated.
- Interchangeable cards for quick maintenance.
- Removable terminal blocks.
POWER SUPPLY OPERATING MODES
- Selector set A-B:
- “A” Position: operating with sound system call, to be used in case of humming noises (caused by power supply, door lock or
lamps) dectected on the interphone line.
- “B” Position: normal operation with Sound System call, switching module in “A” position only in case of humming noises on the
audio line.
- “B” Position: operating with 15V A.C. call only. In this case power supply 6680 completely replaces power supply type 6580.
PROTECTION OF POWER SUPPLY:
- Primary coil of transformer by PTC
- 1st. secondary coil for internal electronic supply by F 3,15A 250V (F1) fuse.
- 2nd. secondary coil for lock supply by PTC
- Electronic protection against short-circuits and overloads on
monitor cable riser.
- Electronic protection against overloads to speech unit.
ADJUSTMENTS
P1 - Activation time adjustment for monitor and camera.
P2 - Volume adjustment of speech unit.
P3 - Activation time adjustment for electric lock.
N.B.: The electric door lock must operate by way of an intermittent cycle so that one
operating period corresponds to 5 rest periods, thereby preventing the protection
device from overheating (one period corresponds to the door lock activation time).
Dimensions type 6680 - 6680/V03: 208x135x72 - Weight: 1.4 Kgs.
Removable terminal blocks
Selector A-B
Bekijk gratis de handleiding van Vimar ELVOX 6680/V04, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vimar |
| Model | ELVOX 6680/V04 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 7131 MB |
