VigilLink VLKV-H2041M handleiding
Handleiding
Je bekijkt pagina 19 van 31
16/28
X
ound
X
3-pin Phoenix connector
RS-232
USB to RS-232 serial cable
Follow the steps below to connect the Controller software and the device.
Step 1. Connect the RS-232 port of the switcher to a PC with an RS-232
serial cable and an USB to RS-232 serial cable, as shown in the figure
below.
T
Gr
R
PC
Step 2. Launch the installed Controller software. (The default language is
English, and you can set the language on the upper right corner of the main
page.) Select “COM Control Mode” on the “General” page, then select the
Port number and Baud Rate (default: 115200), and finally click “Connect”.
After successful connection, the “General” page will display the relevant
information of the connected device, and the status bar at the bottom will
display “Connected”.
Bekijk gratis de handleiding van VigilLink VLKV-H2041M, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | VigilLink |
| Model | VLKV-H2041M |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3538 MB |
