VigilLink VLIP-JP1G-CTRL handleiding
Handleiding
Je bekijkt pagina 50 van 55
Note: When DHCP is set to “O” which is in Static IP mode, the network settings
of Video LAN and Encoders/Decoders should stay in same network segment.
Otherwise, Encoders/Decoders would be showed as oine. In this case, you
should change Video LAN or Encoders/Decoders IP settings to be in same network
segment to bring Encoders/Decoders back online. If the Encoders/Decoders are
actually alive in the system but with incorrect network segment settings, even
though Encoders/Decoders are showing oine, their network settings including IP
address can be changed and set.
4. Controller Reset: Click “Settings Reset” to reset controller
all settings except network settings; Click “Network Reset”
to reset controller network settings; Click “Reset All” to reset
controller all settings including network settings.
■ Firmware Update Page
1. Upload User EDID 1/2: Click the button to open an EDID
binary le and upload it to User EDID 1/2.
2. Upload Decoder Logo Picture: Click the button to upload
the Decoder Logo Picture. Then click “Update All” to apply the
picture for all Decoders or click “Update” to apply the picture
for a single Decoder.
Note: The jpg picture must be greater than 4kB, less than or
equal to 512kB, and the resolution of the picture must be less
than or equal to 1920x1080.
Connecting for a Smarter Future
50
Bekijk gratis de handleiding van VigilLink VLIP-JP1G-CTRL, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | VigilLink |
| Model | VLIP-JP1G-CTRL |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4882 MB |
