Vevor SMS-002 handleiding
Handleiding
Je bekijkt pagina 12 van 128
- 10 -
After use, please clean the stripping machine in time to remove residual
cable skin and debris.Store the stripping machine in a dry, ventilated
place to avoid rust or damage to the blades.
4 Compliance with regulations
Strictly follow the operating procedures in this manual to avoid
equipment damage or personal injury caused by illegal operation.
6ćTroubleshooting
If the stripping machine fails to strip the wire during the stripping
process, there may be several reasons:
(i) The diameter of the stripped wire is too small (the diameter of the
wire to be treated shall not be less than 1.5mm including the outer skin)
(ii) The center of the blade and the center of the V-groove formed by
the two rolling gear are not on a line
(iii) If the blade edge is not sharp, replace it with a new blade.
Do not put your hand into the machine when it is running (be sure to
stop the machine first, press the stop button and then check and debug
and troubleshoot the machine). Do not touch the cutting edge directly
with your hand to avoid cutting the handle.
(iiii)If the motor cannot start normally, first cut off the power supply,
and then turn out the fuse as shown in the figure below to check
whether the fuse is normal.If burned, please replace the fuse with the
same specifications.
(iiiii) Abnormal operation of equipment, may be internal parts of the
equipment damaged or loose.Please check the connection of each part
of the equipment, if loose or damaged, please repair or replace in time.
Bekijk gratis de handleiding van Vevor SMS-002, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vevor |
| Model | SMS-002 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 16728 MB |
